Spec. No. JENF243E-0003Q-01 P 2 / 8
MURATA MFG. CO., LTD.
Reference
Only
■ Insertion Loss Characteristics (I.L.) (Typ.)
6. Marking
No marking.
7. Electrical Performance
No. Item Specification Test Method
7.1 Capacitance Meet item 3.
Table 1
Capacitance Voltage Frequency
33,68,100 (pF) 1 to 5 V(rms) 1MHz±10%
180,360,680
1000 (pF)
1±0.2 V(rms) 1kHz±10%
4700 (pF) 0.1 max.V(rms) 1kHz±10%
7.2 Insulation
Resistance(I.R.)
Meet item 3. Voltage : 50 V(DC)
Time : 60 ± 5 seconds
7.3 Withstanding
Voltage
Products shall not be damaged. Test Voltage : 125 V(DC)
Testing Time : 1 to 5 seconds
Limit the charging current: 10mA max.
8. Mechanical Performance
No. Item Specification Test Method
8.1 Appearance and
Dimensions
Meet item 5. Visual Inspection and measured with Slide
Calipers
8.2 Solderability The electrodes shall be at least 75%
covered with new solder coating.
Flux : Ethanol solution of rosin, 25(wt)%
Pre-heat : 150 ± 10 °C, 60 ~ 90 s
Solder : Sn-3.0Ag-0.5Cu
Solder Temperature : 240 ± 3 °C
Immersion Time : 3 ± 1 s
Immersion and emersion rates : 25mm / s
8.3 Resistance to
soldering heat
Meet Table 2.
Table 2
Flux : Ethanol solution of rosin, 25(wt)%
Pre-heat : 150 ± 10 °C, 60 ~ 90 s
Solder : Sn-3.0Ag-0.5Cu
Solder Temperature : 270 ± 5 °C
Immersion Time : 10 ± 1 s
Immersion and emersion rates : 25mm / s
Then measured after exposure the room
condition for 4 to 48 hours.
Appearance No damaged
Cap. Change
33,68,100
180,360
680 (pF)
Within
±15%
1000
4700(pF)
Within
±30%
I.R. 1000 M min.
Withstanding
Voltage
No damaged