LT5570
2
5570f
PIN CONFIGURATION ABSOLUTE MAXIMUM RATINGS
Supply Voltage .........................................................5.5V
Enable Voltage .................................–0.3V to V
CC
+ 0.3V
Input Signal Power (Differential) ..........................15dBm
T
JMAX
.................................................................... 125°C
Operating Temperature Range.................. –40°C to 85°C
Storage Temperature Range ................... –65°C to 125°C
CAUTION: This part is sensitive to electrostatic discharge. It
is very important that proper ESD precautions be observed
when handling the LT5570.
(Note 1)
TOP VIEW
DD PACKAGE
10-LEAD (3mm s 3mm) PLASTIC DFN
10
9
6
7
8
4
5
3
2
1
FLTR
EN
DNC
DNC
OUT
V
CC
IN
+
DEC
IN
–
GND
T
JMAX
= 125°C, θ
JA
= 43°C/W
EXPOSED PAD (PIN 11) IS GND, MUST BE SOLDERED TO PCB
PARAMETER CONDITIONS MIN TYP MAX UNITS
AC Input
Input Frequency Range (Note 4)
l
40 to 2700 MHz
Input Impedance 200/1 Ω/pF
f
RF
= 500MHz
RF Input Power Range CW Input; 1:4 Balun Matched into 50Ω Source –52 to 13 dBm
Linear Dynamic Range (Note 5) ±1dB Linearity Error, T
A
= –40°C to 85°C 62 dB
Output Slope 36.9 mV/dB
Logarithmic Intercept –54.8 dBm
Output Variation vs Temperature Normalized to Output at 25°C
–40°C < T
A
< 85°C; P
IN
= –50dBm to 13dBm
±0.5 dB
Deviation from CW Response 11dB Peak to Average Ratio (3-Carrier CDMA2K)
12dB Peak to Average Ratio (4-Carrier WCDMA)
0.4
0.3
dB
dB
2
nd
Order Harmonic Distortion At RF Input; CW Input; P
IN
= 10dBm 61 dBc
3
rd
Order Harmonic Distortion At RF Input; CW Input; P
IN
= 10dBm 66 dBc
The l denotes the specifi cations which apply over the full operating
temperature range, otherwise specifi cations are at T
A
= 25°C, V
CC
= 5V, EN = 5V, unless otherwise noted. Test circuits are shown in
Figures 1 and 3. (Notes 2 and 3).
ORDER INFORMATION
LEAD FREE FINISH TAPE AND REEL PART MARKING PACKAGE DESCRIPTION TEMPERATURE RANGE
LT5570IDD#PBF LT5570IDD#TRPBF LCJQ
10-Lead (3mm × 3mm) Plastic DFN
–40°C to 85°C
Consult LTC Marketing for parts specifi ed with wider operating temperature ranges.
Consult LTC Marketing for information on non-standard lead based fi nish parts.
For more information on lead free part marking, go to: http://www.linear.com/leadfree/
For more information on tape and reel specifi cations, go to: http://www.linear.com/tapeandreel/
ELECTRICAL CHARACTERISTICS