2004-2013 Microchip Technology Inc. DS21896C-page 7
MCP1630/MCP1630V
TEMPERATURE SPECIFICATIONS
Current Sense Input
Maximum Current Sense Signal
MCP1630
V
CS_MAX
0.85 0.9 0.95 V Set by maximum error amplifier
clamp voltage, divided by 3.
Delay From CS to V
EXT
MCP1630
T
CS_VEXT
—1225ns
Maximum Current Sense Signal
MCP1630V
V
CS_MAX
2.55 2.7 2.85 V V
IN
> 4.25V
Maximum CS input range limited by
comparator input common mode
range. V
CS_MAX
=V
IN
-1.4V
Delay From CS to V
EXT
MCP1630V
T
CS_VEXT
— 17.5 35 ns
Minimum Duty Cycle DC
MIN
—— 0 %V
FB
=V
REF
+0.1V,
V
CS
=GND
Current Sense Input Bias Current I
CS_B
—-0.1— µAV
IN
=5V
Internal Driver
R
DSON
P-channel R
DSon_P
—1030
R
DSON
N-channel R
DSon_N
—730
V
EXT
Rise Time T
RISE
—5.918 nsC
L
= 100 pF
Typical for V
IN
=3V
V
EXT
Fall Time T
FALL
—6.218 nsC
L
= 100 pF
Typical for V
IN
=3V
Protection Features
Under Voltage Lockout UVLO 2.7 — 3.0 V V
IN
falling, V
EXT
low state when in
UVLO
Under Voltage Lockout Hysteresis UVLO
HYS
50 75 150 mV
Thermal Shutdown T
SHD
— 150 — °C
Thermal Shutdown Hysteresis T
SHD_HYS
—18—°C
Electrical Specifications: V
IN
= 3.0V to 5.5V, F
OSC
= 1 MHz with 10% Duty Cycle, C
IN
= 0.1 µF. T
A
= -40°C to +125°C.
Parameters Sym Min Typ Max Units Conditions
Temperature Ranges
Operating Junction Temperature Range T
A
-40 — +125 °C Steady state
Storage Temperature Range T
A
-65 — +150 °C
Maximum Junction Temperature T
J
— — +150 °C Transient
Thermal Package Resistances
Thermal Resistance, 8L-DFN
(2 mm x 3 mm)
JA
— 50.8 — °C/W Typical 4-layer board with two
interconnecting vias
Thermal Resistance, 8L-MSOP
JA
— 208 — °C/W Typical 4-layer board
AC/DC CHARACTERISTICS (CONTINUED)
Electrical Specifications: Unless otherwise noted, V
IN
= 3.0V to 5.5V, F
OSC
= 1 MHz with 10% Duty Cycle, C
IN
= 0.1 µF,
V
IN
for typical values = 5.0V, T
A
= -40°C to +125°C.
Parameters Sym Min Typ Max Units Conditions
Note 1: Capable of higher frequency operation depending on minimum and maximum duty cycles needed.
2: External oscillator input (OSC IN) rise and fall times between 10 ns and 10 µs used for characterization testing. Signal
levels between 0.8V and 2.0V with rise and fall times measured between 10% and 90% of maximum and minimum
values. Not production tested.
3: The reference input of the internal amplifier is capable of rail-to-rail operation.