UG-174 Evaluation Board User Guide
Rev. 0 | Page 4 of 12
Table 3. LED Functions
LED Corresponding Node Description
D6 6V2 The LEDs used to indicate the status of the on-board voltage rails.
D7 1V The LEDs used to indicate the status of the on-board voltage rails.
D8 2.5V The LEDs used to indicate the status of the on-board voltage rails.
D4 3.3V The LEDs used to indicate the status of the on-board voltage rails.
D3 5V The LEDs used to indicate the status of the on-board voltage rails.
D2
OV
The LEDs used to indicate the status of the ADM2914 outputs.
D1
UV
The LEDs used to indicate the status of the ADM2914 outputs.
Table 4. Connector Functions
Connector Description
J1 Input power connector. Connect J1 to the 8.5 V to 20 V voltage source.
J3 Input power connector for wall adaptor. Connect J3 to the 8.5 V to 20 V power adaptor. Tip negative.