5
INDUSTRIAL TEMPERATURE RANGE
IDT5T929
PRECISION CLOCK GENERATOR OC-48 APPLICATIONS
DC ELECTRICAL CHARACTERISTICS OVER OPERATING RANGE FOR LVTTL
Symbol Parameter Test Conditions Min. Typ. Max Unit
IIH Input HIGH Current VDD = 3.465V — — ±1 μA
IIL Input LOW Current VDD = 3.465V — — ±1
VIK Clamp Diode Voltage VDD = 2.375V, IIN = -18mA — - 0.7 - 1.2 V
VIN DC Input Voltage - 0.3 — +3.465 V
VIH DC Input HIGH 1.7 — — V
V
IL DC Input LOW — — 0.7 V
DC ELECTRICAL CHARACTERISTICS OVER OPERATING RANGE FOR LVPECL
(1)
Symbol Parameter Test Conditions Min. Typ. Max. Unit
Input Characteristics
IIN Input Current (CLKIN, REFIN) VDD = 3.465V -20 — +20 μA
VCMR Common Mode Input Voltage 1 — VDD - 0.3 V
VDIF Differential Voltage Required to Toggle Input 100 ——mV
Output Characteristics
VOH Output Voltage HIGH (terminated through 50Ω tied to VDD - 2V)
(2)
VDD - 1.15 — VDD - 0.9 V
VOL Output Voltage LOW (terminated through 50Ω tied to VDD - 2V)
(2)
VDD - 1.95 — VDD - 1.61 V
VSWING Peak-to-Peak Output Voltage Swing 0.55 — 0.93 V
NOTES:
1. VDD = 2.375 - 3.645V.
2. Not to exceed VDD - 0.05V.
POWER SUPPLY CHARACTERISTICS
(1,2)
Symbol Parameter Test Conditions Typ. Max Unit
IDD_PD Power Supply Current VDD = Max., PD = GND, All outputs unloaded — 50 μA
ΔI
DD Power Supply Current per Input HIGH VDD = Max., VIN = 2.375V — 100 μA
(LVTTL inputs only)
ITOT Total Power Supply Current VDD = Max., QOUT = 622MHz, All outputs unloaded — 200 mA
NOTES:
1. These power consumption characteristics are for all the valid input interfaces and cover the worst case input and output interface combinations.
2. As a general requirement, these parts must be capable of operating at the maximum frequency under a nominal load at a reasonable operating temperature. That means that
these parts must not burn up under extended use in a typical application.
NOTE:
1. These inputs are normally wired to VDD or GND. If these inputs are switched dynamically after powerup, the function and timing of the outputs may be glitched, and the PLL may
require additional tAQ time before all datasheet limits are achieved.
DC ELECTRICAL CHARACTERISTICS OVER OPERATING RANGE
Symbol Parameter Test Conditions Min. Max Unit
VIHH Input HIGH Voltage Level
(1)
2-Level Inputs Only VDD – 0.4 — V
VILL Input LOW Voltage Level
(1)
2-Level Inputs Only — 0.4 V
I
2 2-Level Input DC Current VIN = VDD HIGH Level — 200 μA
V
IN = GND LOW Level –200 —