ST7-EPB Appendix B Safety Requirements
UM0028 Rev 4 13/15
Appendix B Safety Requirements
Any tester, equipment, or tool used at any production step, or for any manipulation of
semiconductor devices, must have its shield connected to ground.
The product must be placed on a conductive table top, made of steel or clean
aluminum
, or covered by an antistatic surface (superficial resistivity equal to or higher than 0.5
M/cm
2
), grounded through a ground cable (conductive cable from protected equipment to
ground isolated with a 1 M resistor placed in series)
. All manipulation of finished goods
goods must be done at such a grounded worktable.
The worktable must be free of all non-antistatic plastic objects.
An antistatic floor covering grounded through a conductive ground cable (with serial
resistor between 0.9 and 1.5 M) should be used.
It is recommended that you wear an antistatic wrist or ankle strap, connected to the
antistatic floor covering or to the grounded equipment.
If no antistatic wrist or ankle strap is worn, before each manipulation of the powered-on
tool, touch the surface of the grounded worktable.
It is recommended that antistatic gloves or finger coats be worn.
It is recommended that nylon clothing be avoided while performing any manipulation of
parts.
www.st.com
Appendix C Product Support ST7-EPB
14/15 UM0028 Rev 4
Appendix C Product Support
If you experience any problems with this product, or if you need spare parts or repairs,
contact the distributor or the STMicroelectronics sales office where you purchased the
product. Phone numbers for major sales regions are provided in the
Contact List
, below.
In addition, at our Internet site www.st.com/mcu, you will find a complete listing of ST sales
offices and distributors, as well as documentation, software downloads and user discussion
groups to help you answer questions and stay up to date with our latest product
developments.
Software updates
All our latest software and related documentation are available for download from the ST
Internet site, www.st.com/mcu. For information about firmware and hardware revisions,
call your distributor or ST using the
Contact List
provided below.
Contact List
North America
West Coast
STMicroelectronics, Inc.
1060 E. Brokaw Road
San Jose, CA 95131
Phone: (408) 452-8585
Mid West
STMicroelectronics
1300 East Woodfield Road,
Suite 410
Schaumburg, IL 60173
Phone: (847) 585-3000
Canada and East Coast
STMicroelectronics
Lexington Corporate Center
10 Maguire Road, Building 1,
3rd floor
Lexington, MA 02421
Phone: (781) 402-2650
Note: For American and Canadian customers seeking technical support the
US/Canada is split in 3 territories. According to your area, contact the
appropriate sales office from the list above and ask to be transferred to an 8-bit
microcontroller Field Applications Engineer.
Europe
France
Germany
U.K.
+33 (0)1 47 40 75 75
+49 89 46 00 60
+44 162 889 0800
Asia/Pacific Region
Japan
Hong-Kong
Sydney
Taipei
+81 3 3280 4120
+85 2 2861 5700
+61 2 9580 3811
+88 6 2 2378 8088
www.st.com
UM0028 Rev 4 15/15
Please Read Carefully:
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the
right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any
time, without notice.
All ST products are sold pursuant to ST’s terms and conditions of sale.
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no
liability whatsoever relating to the choice, selection or use of the ST products and services described herein.
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this
document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products
or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such
third party products or services or any intellectual property contained therein.
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED
WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS
OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.
UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZE REPRESENTATIVE OF ST, ST PRODUCTS ARE NOT DESIGNED,
AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING APPLICATIONS,
NOR IN PRODUCTS OR SYSTEMS, WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY, DEATH, OR
SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE.
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void
any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any
liability of ST.
ST and the ST logo are trademarks or registered trademarks of ST in various countries.
Nomadik is a registered trademark of STMicroelectronics in Hong Kong, Japan, South Korea, Taiwan, International (China, Switzerland,
Norway, Singapore, Turkey) European Community (CEE countries). Registration is pending in Canada, USA and Israel.
Information in this document supersedes and replaces all information previously supplied.
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.
© 2006 STMicroelectronics - All rights reserved
STMicroelectronics group of companies
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -
Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America
www.st.com

ST7MDT2-EPB2/US

Mfr. #:
Manufacturer:
STMicroelectronics
Description:
BOARD PROGRAMMING SGL POS ST7
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union

Products related to this Datasheet