REVISION C 2/13/15
8737-11 DATA SHEET
5 LOW SKEW, ÷1/÷2
DIFFERENTIAL-TO- 3.3V LVPECL CLOCK GENERATOR
TABLE 5. AC CHARACTERISTICS, V
CC
= 3.3V±5%, TA = 0°C TO 70°C
TABLE 4D. LVPECL DC CHARACTERISTICS, V
CC
= 3.3V±5%, TA = 0°C TO 70°C
Symbol Parameter Test Conditions Minimum Typical Maximum Units
f
MAX
Output Frequency 650 MHz
t
PD
Propagation Delay; NOTE 1
CLK, nCLK
ƒ ≤ 650MHz
1.3 1.7 ns
PCLK, nPCLK 1.2 1.6 ns
tsk(o) Output Skew; NOTE 2, 4 60 ps
tsk(b) Bank Skew; NOTE 4
Bank A 20 ps
Bank B 35 ps
tsk(pp) Part-to-Part Skew; NOTE 3, 4 200 ps
tjit
Buffer Additive Phase Jitter, RMS; refer to
Additive Phase Jitter Section, NOTE 5
0.04 ps
t
R
Output Rise Time 20% to 80% @ 50MHz 300 700 ps
t
F
Output Fall Time 20% to 80% @ 50MHz 300 700 ps
odc Output Duty Cycle 48 50 52 %
All parameters measured at 500MHz unless noted otherwise.
The cycle-to-cycle jitter on the input will equal the jitter on the output. The part does not add jitter.
NOTE 1: Measured from the differential input crossing point to the differential output crossing point.
NOTE 2: Defi ned as skew between outputs at the same supply voltage and with equal load conditions.
Measured at the output differential cross points.
NOTE 3: Defi ned as skew between outputs on different devices operating at the same supply voltages
and with equal load conditions. Using the same type of inputs on each device, the outputs are measured
at the differential cross points.
NOTE 4: This parameter is defi ned in accordance with JEDEC Standard 65.
NOTE 5: Driving only one input clock.
Symbol Parameter Test Conditions Minimum Typical Maximum Units
I
IH
Input High Current
V
IN
= V
CC
= 3.465V 150 µA
V
IN
= V
CC
= 3.465V 5 µA
I
IL
Input Low Current
V
IN
= 0V, V
CC
= 3.465V -5 µA
V
IN
= 0V, V
CC
= 3.465V -150 µA
V
PP
Peak-to-Peak Input Voltage 0.3 1 V
V
CMR
Common Mode Input Voltage; NOTE 1, 2 V
EE
+ 1.5 V
CC
V
V
OH
Output High Voltage; NOTE 3 V
CC
- 1.4 V
CC
- 0.9 V
V
OL
Output Low Voltage; NOTE 3 V
CC
- 2.0 V
CC
- 1.7 V
V
SWING
Peak-to-Peak Output Voltage Swing 0.65 1.0 V
NOTE 1: Common mode voltage is defi ned as V
IH
.
NOTE 2: For single ended applications, the maximum input voltage for PCLK, nPCLK is V
CC
+ 0.3V.
NOTE 3: Outputs terminated with 50Ω to V
CC
- 2V.