4©2015 Integrated Device Technology, Inc. Revision B, December 1, 2015
8530I-01 Datasheet
Table 4B. Differential Input DC Characteristics, V
CC
= V
CCO
= 3.3V ± 5%, V
EE
= 0V, T
A
= -40°C to 85°C
NOTE 1: V
IL
should not be less than -0.3V.
NOTE 2: Common mode input voltage is defined as V
IH.
Table 4C. LVPECL DC Characteristics, V
CC
= V
CCO
= 3.3V ± 5%, V
EE
= 0V, T
A
= -40°C to 85°C
NOTE 1: Outputs terminated with 50 to V
CCO
– 2V.
AC Electrical Characteristics
Table 5. AC Electrical Characteristics, V
CC
= V
CCO
= 3.3V ± 5%, V
EE
= 0V, T
A
= -40°C to 85°C
NOTE: Electrical parameters are guaranteed over the specified ambient operating temperature range, which is established when device is
mounted in a test socket with maintained transverse airflow greater than 500 lfpm. Device will meet specifications after thermal equilibrium has
been reached under these conditions.
NOTE: All parameters measured at 250MHz unless noted otherwise.
NOTE 1: Measured from the differential input crossing point to the differential output crossing point.
NOTE 2: This parameter is defined in accordance with JEDEC Standard 65.
NOTE 3: Defined as skew between outputs at the same supply voltage and with equal load conditions. Measured at the differential cross
points.
NOTE 4: Defined as skew between outputs on different devices operating at the same supply voltage, same temperature, same frequency and
with equal load conditions. Using the same type of inputs on each device, the outputs are measured at the differential cross points.
Symbol Parameter Test Conditions Minimum Typical Maximum Units
I
IH
Input High Current
150 µA
5µA
I
IL
Input Low Current
-5 µA
-150 µA
V
PP
Peak-to-Peak Input Voltage; NOTE 1 0.15 1.3 V
V
CMR
Common Mode Input Voltage; NOTE 1, 2 V
EE
+ 0.5 V
CC
– 0.85 V
Symbol Parameter Test Conditions Minimum Typical Maximum Units
V
OH
Output High Voltage; NOTE 1 V
CCO
– 1.4 V
CCO
– 0.9 V
V
OL
Output Low Voltage; NOTE 1 V
CCO
– 2.0 V
CCO
– 1.7 V
V
SWING
Peak-to-Peak Output Voltage Swing 0.6 1.0 V
Symbol Parameter Test Conditions Minimum Typical Maximum Units
f
OUT
Output Frequency 500 MHz
t
JIT
Buffer Additive Phase Jitter,
RMS; refer to Additive Phase
Jitter Section
106.25MHz,
Integration Range: 12kHz – 20MHz
0.162 ps
212.5MHz,
Integration Range: 12kHz – 20MHz
0.152 ps
t
PD
Propagation Delay; NOTE 1 1 2 ns
tsk(o) Output Skew; NOTE 2, 3 75 ps
tsk(pp) Part-to-Part Skew; NOTE 2, 4 700 ps
odc Output Duty Cycle 47 53 %
t
R
/ t
F
Output Rise/ Fall Time 20% to 80% 300 700 ps