1996 Sep 04 19
Philips Semiconductors Product specification
Light position controller TDA3629
Fig.15 Component placement of the printed-circuit board.
handbook, full pagewidth
MGE854
R1
R2
R7
R6
R5
R4
C4
C3
C5
C6
C1
IC1
D2
D1
C2
RFG
GND
+13 V
RFS
CONTROL
RFC
OUT1
OUT2
70%5030
J1
R9 R8
Fig.16 Top view of printed-circuit board.
handbook, full pagewidth
MGE855
1996 Sep 04 20
Philips Semiconductors Product specification
Light position controller TDA3629
Fig.17 Bottom view of printed-circuit board.
handbook, full pagewidth
MGE856
Test results
Fig.18 Typical immunity results with respect to setting of jumper 1 (30, 50 and 70%) RF input to RFC.
(1) Feedback voltage is 30%.
(2) Feedback voltage is 50%.
(3) Feedback voltage is 70%.
(4) Immunity level.
handbook, full pagewidth
0
30
V
RF(rms)
(V)
10
2
10
3
MGE858
10
(1)
(2)
(3)
(4)
frequency (MHz)
110
1
10
20
device accepted
device not accepted
1996 Sep 04 21
Philips Semiconductors Product specification
Light position controller TDA3629
The typical immunity results of the TDA3629T are shown in Fig.18. The RF voltage was injected into the control line
(see also Figs 13 and 14). This injection point is the most sensitive one that could be found. This is underlined by the
comparison results shown in Fig.19.
Fig.19 Typical immunity results with respect to RF injection points, with jumper 1 set to 50%.
(1) RF voltage injection point to ground and to battery voltage.
(2) RF voltage injection point to control path.
(3) Immunity level.
handbook, full pagewidth
0
30
V
RF(rms)
(V)
10
2
10
3
MGE857
10
frequency (MHz)
110
1
10
20
device accepted
device not accepted
(1)
(2)
(3)

TDA3629T/YM,112

Mfr. #:
Manufacturer:
NXP Semiconductors
Description:
Motor / Motion / Ignition Controllers & Drivers LIGHT POSITION CONTROLLER
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union