STANDARD
MICROCIRCUIT DRAWING
SIZE
A
5962-87771
DLA LAND AND MARITIME
COLUMBUS, OHIO 43218-3990
REVISION LEVEL
G
SHEET
3
DSCC FORM 2234
APR 97
1.3 Absolute maximum ratings. 1/
Supply voltage (V
CC
) ................................................................................................. 20 V
Differential input voltage ............................................................................................ 30 V
Input voltage .............................................................................................................. Supply voltage
Output short-circuit duration ...................................................................................... Continuous
Power dissipation (P
D
) .............................................................................................. 800 mW
Storage temperature range ....................................................................................... -65C to +150C
Lead temperature range (soldering, 60 seconds) ...................................................... +300C
Junction temperature (T
J
) .......................................................................................... -65C to +150C
Thermal resistance, junction-to-case (
JC
) ................................................................ See MIL-STD-1835
Thermal resistance, junction-to-ambient (
JA
):
Cases C and K ....................................................................................................... 91C/W
Case 3 .................................................................................................................... 110C/W
1.4 Recommended operating conditions.
Ambient operating temperature range (T
A
) ............................................................... -55C to +125C
Supply voltage (V
CC
) ................................................................................................. 15 V
1.5 Radiation features.
Maximum total dose available (high dose rate = 50 – 300 rad(Si)/s) ......................... 100 krad(Si) 2/
2. APPLICABLE DOCUMENTS
2.1 Government specification, standards, and handbooks. The following specification, standards, and handbooks form a part
of this drawing to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the
solicitation or contract.
DEPARTMENT OF DEFENSE SPECIFICATION
MIL-PRF-38535 - Integrated Circuits, Manufacturing, General Specification for.
DEPARTMENT OF DEFENSE STANDARDS
MIL-STD-883 - Test Method Standard Microcircuits.
MIL-STD-1835 - Interface Standard Electronic Component Case Outlines.
DEPARTMENT OF DEFENSE HANDBOOKS
MIL-HDBK-103 - List of Standard Microcircuit Drawings.
MIL-HDBK-780 - Standard Microcircuit Drawings.
(Copies of these documents are available online at http://quicksearch.dla.mil or from the Standardization Document Order
Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
______
1/ Stresses above the absolute maximum rating may cause permanent damage to the device. Extended operation at the
maximum levels may degrade performance and affect reliability.
2/ These parts may be dose rate sensitive in a space environment and may demonstrate enhanced low dose rate sensitivity
effects. Radiation end point limits for the noted parameters are guaranteed only for the conditions specified in
MIL-STD-883, method 1019, condition A.