33
IDT82V2048 OCTAL T1/E1 SHORT HAUL LINE INTERFACE UNIT INDUSTRIAL TEMPERATURE RANGES
3.2 REGISTER DESCRIPTION
3.2.1 PRIMARY REGISTERS
ID: Device ID Register (R, Address = 00H)
Symbol Position Default Description
ID[7:0] ID.7-0 10H
An 8-bit word is pre-set into the device as the identification and revision number. This number is different with the functional
changes and is mask programmed.
ALB: Analog Loopback Configuration Register (R/W, Address = 01H)
Symbol Position Default Description
ALB[7:0] ALB.7-0 00H
0 = Normal operation. (Default)
1 = Analog Loopback enabled.
RLB: Remote Loopback Configuration Register (R/W, Address = 02H)
Symbol Position Default Description
RLB[7:0] RLB.7-0 00H
0 = Normal operation. (Default)
1 = Remote Loopback enabled.
TAO: Transmit All Ones Configuration Register (R/W, Address = 03H)
Symbol Position Default Description
TAO[7:0] TAO.7-0 00H
0 = Normal operation. (Default)
1 = Transmit all ones.
LOS: Loss of Signal Status Register (R, Address = 04H)
Symbol Position Default Description
LOS[7:0] LOS.7-0 00H
0 = Normal operation. (Default)
1 = Loss of signal detected.
DF: Driver Fault Status Register (R, Address = 05H)
Symbol Position Default Description
DF[7:0] DF.7-0 00H
0 = Normal operation. (Default)
1 = Driver fault detected.
LOSM: Loss of Signal Interrupt Mask Register (R/W, Address = 06H)
Symbol Position Default Description
LOSM[7:0] LOSM.7-0 00H
0 = LOS interrupt is not allowed. (Default)
1 = LOS interrupt is allowed.
DFM: Driver Fault Interrupt Mask Register (R/W, Address = 07H)
Symbol Position Default Description
DFM[7:0] DFM.7-0 00H
0 = Driver fault interrupt not allowed. (Default)
1 = Driver fault interrupt allowed.
LOSI: Loss of Signal Interrupt Status Register (R, Address = 08H)
Symbol Position Default Description
LOSI[7:0] LOSI.7-0 00H
0 = (Default). Or after a LOS read operation.
1 = Any transition on LOSn (Corresponding LOSMn is set to ‘1’).