8
Package Characteristics
All Typicals at T
A
= 25°C.
Parameter Symbol Min. Typ. Max. Units Test Conditions
Input-Output Insulation I
I-O
1 µA 45% RH, t = 5 s
V
I-O
= 3 kV dc,
T
A
= 25°C
Input-Output Momentary V
ISO
3750 Vrms RH ≤ 50%, t = 1 min.,
Withstand Voltage T
A
= 25°C
Input-Output Resistance R
I-O
10
12
Ω V
I-O
= 500 V dc
Input-Output Capacitance C
I-O
0.6 pF f = 1 MHz, T
A
= 25°C
Notes:
1. t
PHL
propagation delay is measured from the 50% level on the risiing edge of the input pulse to the 2.5 V level of the falling edge of the V
O
signal. t
PLH
propagation delay is measured from the 50% level on the falling edge of the input pulse to the 2.5 V level of the rising edge of the
V
O
signal.
2. PWD is dened as |t
PHL
- t
PLH
|.
3. t
PSK
is equal to the magnitude of the worst case dierence in t
PHL
and/or t
PLH
that will be seen between units at any given temperature within
the recommended operating conditions.
4. CM
H
is the maximum tolerable rate of rise of the common mode voltage to assure that the output will remain in a high logic state.
5. CM
L
is the maximum tolerable rate of fall of the common mode voltage to assure that the output will remain in a low logic state.
