12 / 15
2DM180506CM
※After each test, exposure at room temperature and humidity condition for 24 hours.
There shall be no abnormality on the electrical specification and appearance.
Rev.F May, 2016
Exposure in high temperature and high humidity
60℃, 90~95%RH, 240H, ※
Thermal shock -30℃/30min to 100℃/30min, 500cycles, ※
Low temperature operation Input voltage:DC24V, Output current:Rated Load
Item Test condition and acceptance criterion
Exposure in high temperature 100℃, 240H, ※
Exposure in low temperature -30℃, 240H, ※
high temperature Input voltage:DC24V, Output current:Rated Load
and high humidity operation 60℃, 90~95%RH, 240H, ※
Vibration
Vibration amplitude:1.5mm(peak to peak), Vibration Frequency:10 to 55Hz, Sweeping:1min.
-30℃, 240H, ※
High temperature operation Input voltage:DC24V, Output current:Rated Load
85℃, 240H, ※
Drop test for packaged freights Dorp to concrete. Height:40cm
Dorp surface:1 corner, 3 spines, 6 surfaces, 1 time each.
Solderblity Sample shall be dipped into the solution of Methanol and Rosin
In each X,Y and Z direction:once, 120min. ※
Impact
Acceleration:490m/s
2
(50G), Operating time:11ms
In each ±X,Y and Z direction:3 times, ※
and pulled up. After above treatment, the sample shall be coveredby solder uniformly
at more than 75% of circumference and shall not show any unusual appearance.
Resistance to soldering heat Sample shall be dipped into the solution of Methanol and Rosin
(having 75% Methanol and having 25% Rosin by weight measuring)
and shall be dippend into the solder bath having the solder Sn-3Ag-0.5Cu
of 250±5℃ to the position to 3mm from the end of terminal for 3.0±0.5 seconds,
(having 75% Methanol and having 25% Rosin by weight measuring)
and shall be dippend into the solder bath having the solder Sn-3Ag-0.5Cu
of 260±5℃ to the position to 3mm from the end of terminal for 10.0±0.5
seconds, and pulled up. After that sample shall be replace in normal ambient
for 1~2 hours and shall not show any unusual appearance.