OMO ElectronicOMO Electronic
Expand menu
Hello, Sign inMy Account
0 Cart

AFCT-57R5ATPZ

P1-P3P4-P6P7-P9P10-P12P13-P15P16-P18P19-P20
13
Table 10. Transceiver Digital Diagnostic Monitor (Real Time Sense) Characteristics
(T
C
= -15°C to 85°C, VccT, VccR = 3.3 V ± 10%)
Parameter Symbol Min. Units Notes
Transceiver Internal Temperature T
INT
±3.0 °C Temperature is measured internal to the transceiver.
Accuracy Valid from = -10°C to 85°C case temperature.
Transceiver Internal Supply V
INT
±0.1 V Supply voltage is measured internal to the transceiver
Voltage Accuracy and can, with less accuracy, be correlated to
voltage at the SFP Vcc pin. Valid over 3.3 V ± 10%.
Transmitter Laser DC Bias Current I
INT
±10 % I
INT
is better than ±10% of the nominal value.
Accuracy
Transmitted Average Optical P
T
±3.0 dB Coupled into 9/125 μm single-mode  ber. Valid from
Output Power Accuracy 100 μW to 500 μW, average.
Received Optical Input Power P
R
±3.0 dB Coupled from 9/125 μm single-mode  ber. Valid from
Accuracy 15 μW to 500 μW, average.
14
Figure 4. Transceiver timing diagrams (module installed except where noted).
TX_FAULT
V
CC
T,R > 2.97 V
t_init
TX_DISABLE
TRANSMITTED SIGNAL
t_init
TX_FAULT
V
CC
T,R > 2.97 V
TX_DISABLE
TRANSMITTED SIGNAL
t-init: TX DISABLE NEGATED t-init: TX DISABLE ASSERTED
TX_FAULT
V
CC
T,R > 2.97 V
t_init
TX_DISABLE
TRANSMITTED SIGNAL
t_off
TX_FAULT
TX_DISABLE
TRANSMITTED SIGNAL
t-init: TX DISABLE NEGATED, MODULE HOT PLUGGED t-off & t-on: TX DISABLE ASSERTED THEN NEGATED
INSERTION
t_on
TX_FAULT
OCCURANCE OF FAULT
t_fault
TX_DISABLE
TRANSMITTED SIGNAL
TX_FAULT
OCCURANCE OF FAULT
TX_DISABLE
TRANSMITTED SIGNAL
t-fault: TX FAULT ASSERTED, TX SIGNAL NOT RECOVERED t-reset: TX DISABLE ASSERTED THEN NEGATED, TX SIGNAL RECOVERED
t_reset
t_init*
* SFP SHALL CLEAR TX_FAULT IN
< t_init IF THE FAILURE IS TRANSIENT
TX_FAULT
OCCURANCE OF FAULT
t_fault
TX_DISABLE
TRANSMITTED SIGNAL
OPTICAL SIGNAL
LOS
t-fault: TX DISABLE ASSERTED THEN NEGATED, TX SIGNAL NOT RECOVERED t-loss-on & t-loss-off
t_loss_on
t_init*
t_reset
* SFP SHALL CLEAR TX_FAULT IN
< t_init IF THE FAILURE IS TRANSIENT
t_loss_off
OCCURANCE
OF LOSS
15
Table 12. EEPROM Serial ID Memory Contents – Conventional SFP Memory (Address A0h)
Byte #
Decimal
Data
Hex Notes
Byte #
Decimal
Data
Hex Notes
0 03 SFP physical device 37 00 Hex Byte of Vendor OUI
[2]
1 04 SFP function de ned by serial ID only 38 17 Hex Byte of Vendor OUI
[2]
2 07 LC optical connector 39 6A Hex Byte of Vendor OUI
[2]
3 00 40 41 “A” - Vendor Part Number ASCII character
4 00 41 46 “F” - Vendor Part Number ASCII character
5 00 42 43 “C” - Vendor Part Number ASCII character
6 00 43 54 “T” - Vendor Part Number ASCII character
7 12 Long distance (per FC-PI), Longwave Laser
(LC)
44 2D “-” - Vendor Part Number ASCII character
8 00 45 35 “5” - Vendor Part Number ASCII character
9 01 Single Mode (SM) 46 37 “7” - Vendor Part Number ASCII character
10 15 100, 200 & 400 Mbytes/sec FC-PI speed
[1]
47 52 “R” - Vendor Part Number ASCII character
11 01 Compatible with 8B/10B encoded data 48 35 “5” - Vendor Part Number ASCII character
12 2B 4300 MBit/sec nominal bit rate (4.25 Gbit/s) 41 41 “A” - Vendor Part Number ASCII character
13 00 54 54 “T” - Vendor Part Number ASCII character
14 0A 10 km of 9 μm/125 μm single mode  ber 50 50 “P” - Vendor Part Number ASCII character
15 64 10 km of 9 μm/125 μm single mode  ber 5A 5A “Z” - Vendor Part Number ASCII character
16 00 53 20 “ ” - Vendor Part Number ASCII character
17 00 54 20 “ ” - Vendor Part Number ASCII character
18 00 55 20 “ ” - Vendor Part Number ASCII character
19 00 56 20 “ ” - Vendor Part Number ASCII character
20 41 “A” - Vendor Name ASCII character 57 20 “ ” - Vendor Part Number ASCII character
21 56 “V” - Vendor Name ASCII character 58 20 “ ” - Vendor Part Number ASCII character
22 41 “A” - Vendor Name ASCII character 59 20 “ ” - Vendor Part Number ASCII character
23 47 “G” - Vendor Name ASCII character 60 05 Hex Byte of Laser Wavelength
[3]
24 4F “O” - Vendor Name ASCII character 61 1E Hex Byte of Laser Wavelength
[3]
25 20 “ ” - Vendor Name ASCII character 62 00
26 20 “ ” - Vendor Name ASCII character 63 Checksum for Bytes 0-62
[4]
27 20 “ ” - Vendor Name ASCII character 64 00
28 20 “ ” - Vendor Name ASCII character 65 1A Hardware SFP TX_DISABLE, TX_FAULT, &
RX_LOS
29 20 “ ” - Vendor Name ASCII character 66 00
30 20 “ ” - Vendor Name ASCII character 67 00
31 20 “ ” - Vendor Name ASCII character 68-83 Vendor Serial Number ASCII characters
[5]
32 20 “ ” - Vendor Name ASCII character 84-91 Vendor Date Code ASCII characters
[6]
33 20 “ ” - Vendor Name ASCII character 92 68 Digital Diagnostics, Internal Cal, Rx Pwr Avg
34 20 “ ” - Vendor Name ASCII character 93 F0 A/W, Soft SFP TX_DISABLE, TX_FAULT, &
RX_LOS
35 20 “ ” - Vendor Name ASCII character 94 01 SFF-8472 Compliance to revision 9.3
36 00 95 Checksum for Bytes 64-94
[4]
96 - 255 00
Notes:
1. FC-PI speed 100 MBytes/sec is a serial bit rate of 1.0625 GBit/sec. 200 MBytes/sec is a serial bit rate of 2.125 GBit/sec. 400 MBytes/sec is a serial
bit rate of 4.25 GBit/sec.
2. The IEEE Organizationally Unique Identi er (OUI) assigned to Avago Technologies is 00-17-6A (3 bytes of hex).
3. Laser wavelength is represented in 16 unsigned bits. The hex representation of 1310 (nm) is 051E.
4. Addresses 63 and 95 are checksums calculated (per SFF-8472 and SFF-8074) and stored prior to product shipment.
5. Addresses 68-83 specify the AFCT-57R5ATPZ ASCII serial number and will vary on a per unit basis.
6. Addresses 84-91 specify the AFCT-57R5ATPZ ASCII date code and will vary on a per date code basis.
P1-P3P4-P6P7-P9P10-P12P13-P15P16-P18P19-P20

AFCT-57R5ATPZ

Mfr. #:
Buy AFCT-57R5ATPZ
Manufacturer:
Broadcom / Avago
Description:
TXRX OPT SFP LC 4/2/1GBD LC CONN
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union

Products related to this Datasheet