Spec No. JENF243F-0031A-01 P4/10
MURATA MFG.CO., LTD
Reference Only
No.
Item Specification Test Method
7.5 Withstanding
Voltage
Products shall not be damaged. Test Voltage : 2.5 times for Rated Voltage
Time : 1 to 5 seconds
Charge Current : 10 mA max.
It shall be applied between input / output terminal
and ground terminal.
7.6 Temperature
Characteristics
Meet item 3. Capacitance shall be measured at each step specified
in Table 3 after reaching the thermal equilibrium.
The capacitance change against the capacitance at
step 3 shall be calculated.
Table3
Step 1 2 3 4 5
Temp.
(°C)
+20±2
40±2 +20±2 +85±2+20±2
7.7 Solderability Along the circumference of terminal
shall be covered with new solder at least
75%.
Flux : Ethanol solution of rosin,25(wt)%
(dipped for 5 to 10 seconds)
Pre-heat : 150±10℃, 60～90 s
Solder : Sn-3.0Ag-0.5Cu
Solder Temperature 245±5℃
Immersion Time : 2 ± 0.5 seconds
Immersion Depth :
2 to 2.5 mm from the bottom of the body.
7.8 Resistance to
Soldering Heat①
Meet Table 4.
Table 4
Appearance No damaged.
Capacitance
Change
within ± 30%
Withstanding
Voltage
No damaged.
Flux : Ethanol solution of rosin,25(wt)%
(dipped for 5 to 10 seconds)
Pre-heat : 150±10℃, 60～90 s
Solder : Sn-3.0Ag-0.5Cu
Solder Temperature : 270 ± 5 °C
Immersion Time : 3± 0.5 seconds
Immersion Depth :
1.6 ± 0.7 mm from the bottom of the body.
Then measured after exposure in the room
condition for 4 to 24hours.
Resistance to
Soldering Heat②
Soldering iron output: 30W
Tip temperature : 370±10°C
Soldering time : 5s(+0/-1s)
7.9 Humidity
Meet Table 5.
Table 5
Temperature : 60°C
Humidity : 90 to 95 %(RH)
Time : 500 hours(+24-0 hours)
Then measured after exposure in the room
condition for 4 to 24hours.
7.10 Humidity Life
Temperature : 40 ± 2°C
Humidity : 90 to 95 %(RH)
Time : 500 hours(+24-0 hours)
Applying Voltage : 1H/ Rated Voltage 50VDC
2A/ Rated Voltage 100VDC
Then measured after exposure in the room
condition for 4 to 24hours.
7.11 Heat Life
Temperature : 85 ± 3°C
Applying Voltage : 1H/ Rated Voltage 50VDC
2A/ Rated Voltage 100VDC
Time : 500 hours(+24-0 hours)
Then measured after exposure in the room
condition for 4 to 24hours.
Appearance No damaged.
Capacitance
Change
within ± 30%
Inslation
Resistance
10M
Ω min.
