Spec.No. JENF243H-0008K-01 P 13/ 14
MURATA MFG.CO.,LTD.
Reference Only
(2) Soldering Conditions
Standard soldering profile and the limit soldering profile is as follows.
The excessive soldering conditions may cause leaching of the electrode and/or resulting in the deterioration
of product quality.
Standard Profile Limit Profile
Pre-heating 150°C ~ 180°C , 90s ± 30s
Heating above 220°C , 30s ~ 60s above 230°C , 60s max.
Peak temperature 245°C ± 3°C 260°C , 10s
Cycle of reflow 2 times 2 times
13.7. Reworking with Soldering iron
· The following conditions shall be strictly followed when using a soldering iron.
Pre-heating 150°C,1 min
Tip temperature 450°C max.
Soldering iron output 100W max.
Soldering time 5s
Time 2 times
Note : Do not touch the products directly with the tip of the soldering iron.
13.8. Cleaning Conditions
Avoid cleaning product due to non-waterproof construction.
Please contact us for details, then use.
13.9. Operating Environment
Do not use this product under the following environmental conditions, on deterioration of the performance,
such as insulation resistance may result from the use.
(1) in the corrodible atmosphere (acidic gases, alkaline gases, chlorine, sulfur gases, organic gases and etc.)
(2) in the atmosphere where liquid such as organic solvent, may splash on the products.
13.10. Handling of a substrate
After mounting products on a substrate, do not apply any stress to the product caused by bending or
twisting to the substrate when cropping the substrate, inserting and removing a connector from the
substrate or tightening screw to the substrate.
Excessive mechanical stress may cause cracking in the product.
Bending Twisting
Limit Profile
Standard Profile
90s±30s
230°C
260°C
245°C±3°C
220°C
30s
～
60s
60s max.
180
150
Temp.
Time.(s)
(°C)
