MAX4719
20
Ω
, 300MHz Bandwidth, Dual SPDT Analog
Switch in UCSP
_______________________________________________________________________________________ 5
Note 3: UCSP parts are 100% tested at +25°C only, and guaranteed by design over the specified temperature range. µMAX parts
are 100% tested at T
MAX
and guaranteed by design over the specified temperature range.
Note 4: The algebraic convention used in this data sheet is where the most negative value is a minimum and the most positive
value is a maximum.
Note 5: Guaranteed by design for UCSP parts.
Note 6: ∆R
ON
= R
ON(MAX)
- R
ON(MIN)
.
Note 7: Flatness is defined as the difference between the maximum and minimum value of on-resistance as measured over the
specified analog signal ranges.
Note 8: Guaranteed by design.
Note 9: Between any two switches.
ELECTRICAL CHARACTERISTICS—Single +5V Supply (continued)
(V+ = +4.2V to +5.5V, V
IH
= +2.0V, V
IL
= +0.8V, T
A
= T
MIN
to T
MAX
, unless otherwise noted. Typical values are at V+ = +5.0V,
T
A
= +25°C, unless otherwise noted.) (Notes 3, 4)
ON-RESISTANCE vs. V
ON-RESISTANCE vs. V
ON-RESISTANCE vs. V
Typical Operating Characteristics
(T
A
= +25°C, unless otherwise noted.)