108-151009
Rev B5
There shall be no evidence of cracking,
distortion or detrimental damage to the
connector following the test.
Cycle mated connectors from –55 ±
3°C to +125 ±3°C at a rate of 3°C ±
1°C per minute. Connectors to remain
at each temperature extreme for one
(1) hour minimum. Mated connectors
are to be cycled a total of 20 complete
cycles.
Test samples must meet insulation
resistance.
The wired mated connectors shall be
placed in an oven at +125 ±3°C for two
(2) hours minimum then immediately
be placed in water with a 5% salt by
weight content and 0.1 g/L wetting
solution to a depth of 914mm for four
(4) hours minimum. The free ends of
the mated connectors must remain out
of the water to prevent wicking of the
water through the open wires. Water
temperature to be +23 ±3°C.
Figure 3 end
3.6. Appendix B Test Procedure Comparison Chart
Similar to
SAE J2030
Paragraph
Similar to
ISO 8092-2
Paragraph
Dielectric Withstanding Voltage
Low Level Contact Resistance
