Narrow pitch connectors P5KF (0.5mm pitch)
–3–
ACCTB23E 201602-T
SPECIFICATIONS
1. Characteristics
2. Material and surface treatment
Item Specifications Conditions
Electrical
characteristics
Rated current 0.5A/pin contact (Max. 10 A at total pin contacts)
Rated voltage 60V AC/DC
Dielectric strength 150V AC for 1 minute Detection current: 1mA
Insulation resistance Min. 1,000MΩ (initial) Using 500V DC megger
Contact resistance Max. 90mΩ
Based on the contact resistance measurement method specified by
JIS C 5402.
Mechanical
characteristics
Composite insertion force Max. 0.981N/pin contacts × pin contacts (initial)
Composite removal force Min. 0.0588N/pin contacts × pin contacts
Contact holding force Min. 0.981N/pin contact
Measuring the maximum force.
As the contact & post is axially pull out.
Environmental
characteristics
Ambient temperature –55°C to +85°C No icing or condensation.
Soldering heat resistance
Max. peak temperature of 260°C (on the surface
of the PC board around the connector terminals)
Infrared reflow soldering
300°C within 5 seconds, 350°C within 3 seconds Soldering iron
Storage temperature
–55°C to +85°C (product only)
–40°C to +50°C (emboss packing)
No icing or condensation.
Thermal shock resistance
(header and socket mated)
5 cycles, insulation resistance min. 100MΩ,
contact resistance max. 90mΩ
Conformed to MIL-STD-202F, method 107G
Humidity resistance
(header and socket mated)
120 hours, insulation resistance min. 100MΩ,
contact resistance max. 90mΩ
Conformed to IEC60068-2-78
Bath temperature 40°C±2°C, humidity 90% to 95% R.H.
Saltwater spray resistance
(header and socket mated)
24 hours, insulation resistance min. 100MΩ,
contact resistance max. 90mΩ
Conformed to IEC60068-2-11
Bath temperature 35°C±2°C, saltwarter concentration 5%±1%
H2S resistance
(header and socket mated)
48 hours, contact resistance max. 90mΩ
Bath temperature 40°C±2°C, gas concentration 3 ppm ±1 ppm,
humidity 75% to 80% R.H.
Lifetime
characteristics
Insertion and removal life 50 times Repeated insertion and removal speed of max. 200 times/hours
Unit weight
Mated height 1.5mm, 20 pin contacts;
Socket: 0.06g
Header: 0.04g
Part name Material Surface treatment
Molded portion LCP resin (UL94V-0) —
Contact/Post Copper alloy
Contact portion: Ni plating on base, Au plating on surface
Terminal portion: Ni plating on base, Au plating on surface (Except for thick of terminal)
The section close to the soldering portion has a nickel barrier.
(The nickel base is exposed.)
Order Temperature (°C) Time (minutes)
1
2
3
4
–55
85
–55
0
−3
30
Max. 5
30
Max. 5
+3
0
0
−3
