MAX4589
Low-Voltage, High-Isolation,
Dual 2-Channel RF/Video Multiplexer
_______________________________________________________________________________________ 7
Figure 7 ns200t
CSS1
CS Fall to SCLK Rise Hold Time
C, E
Figure 6
-10 10
I+V+ Supply Current
C, E
ns
CONDITIONS
200t
DS
A_, EN to LE Rise Setup Time
C, E
Figure 7 ns0t
CSH1
CS Rise to SCLK Rise Hold Time
C, E
C
L
= 50pF, Figure 7 ns250t
DO
SCLK Rise to DOUT Valid C, E
UNITSMIN TYP MAXSYMBOLPARAMETER T
A
V+ = 3.6V, V
IN
= 0 or V
L
µA
-1 1+25°C
Figure 7 ns100t
CSS0
CS Fall to SCLK Rise Setup Time
C, E
Figure 6 ns200t
L
LE Low Pulse Width
C, E
Figure 6 ns0t
DH
A_, EN to LE Rise Hold Time
C, E
Figure 7 MHz2.1f
CLK
Operating Frequency C, E
Figure 7 ns200t
CH
SCLK Pulse Width High C, E
Figure 7 ns0t
DH
DIN to SCLK Rise Hold Time C, E
Figure 7 ns200t
CL
SCLK Pulse Width Low C, E
Figure 7 ns100t
DS
DIN to SCLK Rise Setup Time C, E
Note 2: The algebraic convention is used in this data sheet; the most negative value is shown in the minimum column.
Note 3: Guaranteed by design.
Note 4: ∆R
ON
= R
ON(MAX)
- R
ON(MIN)
.
Note 5: Resistance flatness is defined as the difference between the maximum and the minimum value of on-resistance as
measured over the specified analog-signal range.
Note 6: Leakage parameters are 100% tested at maximum rated hot temperature and guaranteed by correlation at T
A
= +25°C.
Note 7: Off-isolation = 20log10 [V
COM_
/ V
NO_
], V
COM_
= output, V
NO_
= input to off switch.
Note 8: Leakage testing for single-supply operation is guaranteed by testing with dual supplies.
ELECTRICAL CHARACTERISTICS—Single +3V Supply (continued)
(V+ = V
L
= +2.7V to +3.6V, V- = 0, V
INH
= +2V, V
INL
= +0.5V, T
A
= T
MIN
to T
MAX
, unless otherwise noted. Typical values are at T
A
=
+25°C, V+ = V
L
= +3V.)
I
L
V
L
Supply Current V
L
= 3.6V, all V
IN
= 0 or V
L
µA-10 1 10C, E
Figure 7 ns200t
CSS1
CS Rise to SCLK Rise Setup
Time
C, E
Figure 6 ns80t
RS
RS Low Pulse Width
C, E
Figure 6 ns80t
RS
RS Low Pulse Width
C, E
PARALLEL-INTERFACE TIMING
SERIAL-INTERFACE TIMING
POWER SUPPLY