SFC3233-02
No.
KYOCERA CORPORATION
2
10/12
13. Precaution in handling
13-1. Application instructions
1) This product is designed to be used for general electronic device and is not designed in the
high reliability application listed below.
Please inform the department in charge when using the product for following applications.
Utility in nuclear power plant Traffic signal control system
Utility in space security and disaster-prevention
Aircraft Transporter (car, train, ship, etc.)
under water or ground Medical
other – applications requires same environmental status as above.
2) This product must not be used in every application which are primary – intended to damage
human race or their property.
Arms (missile, bomb and other application to damage human)
Weapons (transports act for combat )
Controller with primary – intended to military use.
13-2. Operating Environment
1) Use this product within the certified operating temperature.
If not, it may not fulfill the requested electrical characteristic. It may move successfully for a
short time, but it will cause degradation or breakdown, moreover lower the reliability.
2) This product is designed and manufactured with intention to be used in general
electronic equipments for standard applications but with no intention to be used in the
following environments which may affect performance of this product.
Therefore, make sure to have enough confirmation on performance and
reliability of this product in the following environments in advance before use.
・Under corrosive gas （Cl
2
, H
2
S, NH
3
, SOx, NOx, etc.)
・Under volatile and inflammability gas
・Dusty environment
・Under water trickle or dew drop occur from humid.
・Under direct sunlight
・Under high static charge or electric intensity.
Please inform the department in charge when using the product for the application above.
3) This product can’t be used in liquid (water, oil, chemical, organic solvent)
4) Please use under certified voltage.
If not, it may not fulfill the requested electrical characteristic. It may move successfully for a
short time, but it will cause degradation or breakdown, moreover lower the reliability.
5) The face resin is not on the purpose of insulation, do not contact with other components.
6) There might be a strong electrical charge when rapid thermal change is added to this product.
This charge may damage this product and the surrounding circuit. Therefore, please load
discharge path between output-Ground , input-Ground.
7) Please do not load larger stress loaded under the environmental test.
It may move successfully for a short time, but it will cause degradation or breakdown,
moreover lower the reliability.
8) Do not mold this product by transfer molding. It may not have a normal operation from the
sealing break. Please inform the department in charge when molding by resin.
