LPC2104_2105_2106_7 © NXP B.V. 2008. All rights reserved.
Product data sheet Rev. 07 — 20 June 2008 29 of 41
NXP Semiconductors
LPC2104/2105/2106
Single-chip 32-bit microcontrollers
[1] Typical ratings are not guaranteed. The values listed are at room temperature (+25 °C), nominal supply voltages.
[2] Internal rail.
[3] External rail.
[4] Including voltage on outputs in 3-state mode.
[5] V
DD(3V3)
supply voltages must be present.
[6] 3-state outputs go into 3-state mode when V
DD(3V3)
is grounded.
[7] Accounts for 100 mV voltage drop in all supply lines.
[8] Allowed as long as the current limit does not exceed the maximum current allowed by the device.
[9] Minimum condition for V
I
= 4.5 V, maximum condition for V
I
= 5.5 V.
[10] Applies to P0[31:22].
[11] SPI is enabled and SSP is disabled in the PCONP register (
see LPC2104/2105/2106 user manual
).
[12] To V
SS
.
8.1 Power consumption measurements for LPC2104/2105/2106/01
The power consumption measurements represent typical values for the given conditions.
The peripherals were enabled through the PCONP register, but for these measurements
the peripherals were not configured to run. Power measurements with all peripherals
enabled were performed with the SPI enabled and the SSP disabled. Peripherals were
disabled through the PCONP register. Refer to the
LPC2104/2105/2106 User Manual
for a
description of the PCONP register.
Oscillator pins
V
i(XTAL1)
input voltage on pin XTAL1 0 - 1.8 V
V
o(XTAL2)
output voltage on pin
XTAL2
0 - 1.8 V
Table 9. Static characteristics
…continued
T
amb
=0
°
C to +70
°
C for commercial applications, unless otherwise specified.
Symbol Parameter Conditions Min Typ
[1]
Max Unit
Test conditions: Active mode entered executing code from on-chip flash; PCLK =
CCLK
⁄
4
;
T
amb
=25°C; core voltage 1.8 V.
Fig 5. Typical LPC2104/2105/2106/01 I
DD(act)
measured at different frequencies
frequency (MHz)
12 604428
002aad709
20
40
60
I
DD(act)
(mA)
0
all peripherals enabled
all peripherals disabled
