PLD E 400 W ...
106445_en_03 PHOENIX CONTACT 7 / 10
5 Safety notes 6 Illuminance distribution
The illuminance distribution depends on the length of the
light. Please refer to the figures below for the illuminance
distribution.
Figure 1 Lighting level distribution in Lux
PLDE400W250 (installation depth of the
control cabinet plate d=200mm)
WARNING: Explosion hazard
Do not install and operate the light in
potentially explosive spaces!
CAUTION: Impaired vision
Looking at the light continually can
temporarily impair vision. This can increase
the danger of accidents. Therefore do no look
at a light source for a long period.
NOTE: Damage to the electronics
The IP20 degree of protection (IEC 60529/EN
60529) of the device is intended for use in a
clean and dry environment.
Do not subject the device to mechanical and/
or thermal loads that exceed the specified
limits.
NOTE
Before any work on the light, always switch off
the supply voltage and ensure it cannot be
switched on again!
0,00 m 0,95 m
2,00 m
0,00 m
5
20
30
30
30
30
30
30
30
30
60
60
60
60
60
60
60
60
60
90 90
90 90
90
90
20
20
20
20
20
20
20
10
30
10
10
5
5
