DATASHEET
EAPIST3224A2
Copyright © 2010, Everlight Americas Inc
. All Rights Reserved. Release Date : May.05.2014.
XXXXXXXXXX Rev.0.1
www.everlightamericas.com
z Precautions For Use
1. Over-current-proof
Customer must apply resistors for protection , otherwise slight voltage shift will cause big
current change ( Burn out will happen ).
2. Storage
2.1 Do not open moisture proof bag before the products are ready to use.
2.2 Before opening the package, the LEDs should be kept at 30к or less and 90%RH or less.
2.3 The LEDs should be used within a year.
2.4 After opening the package, the LEDs should be kept at 30к or less and 60%RH or less.
2.5 The LEDs should be used within 168 hours (7 days) after opening the package
2.6 If the moisture absorbent material (silica gel) has faded away or the LEDs have exceeded the storage
time, baking treatment should be performed using the following conditions.
Baking treatment : 60̈́5к for Min. 24 hours.
3. Soldering Condition
3.1 Pb-free solder temperature profile
3.2 Reflow soldering should not be done more than two times.
3.3 When soldering, do not put stress on the LEDs during heating.
3.4 After soldering, do not warp the circuit board.
