Document Number: MPC17517
Rev. 2.0, 7/2006
Freescale Semiconductor
Advance Information
* This document contains certain information on a new product.
Specifications and information herein are subject to change without notice.
© Freescale Semiconductor, Inc., 2006. All rights reserved.
1.0 A 6.8 V Dual Motor Driver IC
The 17517 is a monolithic triple totem-pole-output power IC
designed to be used in portable electronic applications to control
small DC motors and solenoids. The 17517 can operate efficiently
with supply voltages as low as 2.0
V to as high as 6.8 V. Its low
R
DS(ON)
totem-pole output MOSFETs (0.46 typical) can provide
continuous drive currents of 1.0
A and handle peak currents up to
3.0
A. It is easily interfaced to low-cost MCUs via parallel 3.0 V- or
5.0
V-compatible logic. The device can be pulse width modulated
(PWM-ed) at up to 200
kHz.
The 17517 can drive two motors in two directions one at a time or
drive one motor in two directions and one solenoid with synchronous
rectification of freewheeling currents one at a time. Two-motor
operation is accomplished by hooking one motor between OUTA and
OUTB and hooking the other motor between OUTB and OUTC. Motor
plus solenoid operation is accomplished by hooking a motor between
OUTA and OUTB and a solenoid between OUTC and GND.
This device contains an integrated charge pump and level shifter
(for gate drive voltages), integrated shoot-through current protection
(cross-conduction suppression logic and timing), and undervoltage
detection and shutdown circuitry.
The 17517 has four operating modes: Forward, Reverse, Brake,
and Tri-Stated (High Impedance).
Features
•2.0 V to 6.8 V Continuous Operation
Output Current 1.0 A (DC), 3.0 A (Peak)
•MOSFETs < 600 m R
DS(ON)
@ 25°C Guaranteed
•3.0 V/ 5.0 V TTL- / CMOS-Compatible Inputs
PWM Frequencies up to 200 kHz
Undervoltage Shutdown
Figure 1. 17517 Simplified Application Diagram
DUAL MOTOR DRIVER
DTB SUFFIX
98ASH70247A
16-PIN TSSOP
17517
ORDERING INFORMATION
Device
Temperature
Range (T
A
)
Package
MPC17517DTB/R2 -20°C to 65°C 16 TSSOP
VDD
Cres
C1L
C1H
C2L
C2H
IN2
IN1
EN1
OUTB
OUTA
OUTC
VM
GND
Solenoid
MCU
EN2
MOTOR
5.0 V 5.0 V
17517
Analog Integrated Circuit Device Data
2 Freescale Semiconductor
17517
INTERNAL BLOCK DIAGRAM
INTERNAL BLOCK DIAGRAM
Figure 2. 17517 Simplified Internal Block Diagram
C2H
C1L
VMAB
VMC
OUTC
OUTB
OUTA
GND
C2L
C1H
VC
IN1
IN2
EN1
EN2
VG
Low Voltage
Detector
Control Logic
OSC, Charge Pump
Level Shifter Predriver
Analog Integrated Circuit Device Data
Freescale Semiconductor 3
17517
PIN CONNECTIONS
PIN CONNECTIONS
Figure 3. 17517 Pin Connections
Table 1. 17517 Pin Definitions
A functional description of each pin can be found in the Functional Pin Description section beginning on page 9.
Pin Number Pin Name Formal Name Definition
1 VDD Control Circuit Power Supply
Positive power source connection for control circuit.
2, 13 VM Motor Drive Power Supply
Motor power supply voltage input pins.
3 OUTA Output A
Driver output A pin.
4 CRES Charge Pump Output Capacitor
Connection
Charge pump reservoir capacitor pin.
5 C2H Charge Pump 2H
Charge pump bucket capacitor 2 (positive pole).
6 C2L Charge Pump 2L
Charge pump bucket capacitor 2 (negative pole).
7 IN1 Input Control 1
Control signal input 1 pin.
8 IN2 Input Control 2
Control signal input 2 pin.
9 EN1 Enable Control Signal Input 1
Enable control signal input 1 pin.
10 EN2 Enable Control Signal Input 2
Enable control signal input 2 pin.
11 C1L Charge Pump 1L
Charge pump bucket capacitor 1 (negative pole).
12 C1H Charge Pump 1H
Charge pump bucket capacitor 1 (positive pole).
14 OUTB Output B
Driver output B pin.
15 GND Ground
Ground connection.
16 OUTC Output C
Driver output C pin.
EN1
OUTC
GND
OUTB
VM
C1H
EN2
C1L
IN2
VDD
VM
OUTA
CRES
C2H
IN1
C2L
8
2
3
4
5
7
6
9
16
15
14
13
12
10
11
1

MPC17517DTBR2

Mfr. #:
Manufacturer:
NXP Semiconductors
Description:
IC MOTOR DRVR 2.7V-5.7V 16TSSOP
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union

Products related to this Datasheet