M52259DEMOKIT—Quick Start Guide
STEP
8
If necessary, manually set up
TCP/IP on the PC
The default IP address of the board is
169.254.3.3. Typically, when you connect
your computer directly to the board,
the computer will default to an auto
IP address on the same subnet as the
board (169.254.x.x), therefore requiring
STEP
9
Open a Web browser and go to
169.254.3.3 to view Web pages
that reside in the MCF5225x
internal flash memory.
The pages are served by the MQX
HTTP Web server from MQX Lab 4, Web-
enabled HVAC System. Use the HVAC
links to control a mock thermostat. See
MQX Training Lab 4 for more information.
no setup. Note: The PC may take a few
minutes to default to the auto IP address
and make the connection.
However, if you have trouble connecting,
you may configure the IP address of
the computer manually. Select Start–
Settings-Network Connections–Local
Area Connection. Note your original
TCP/IP settings, and then set your IP
address to 169.254.3.4 and your subnet
mask to 255.255.0.0.
STEP
10
Insert the included USB mass
storage device into the board
using the mini USB-B adaptor
plug found in the USB cable kit.
Hit F5 to refresh the Web page. A new
link will appear on the left hand side
to allow you to browse the Web pages
stored on the USB mass storage device.
