MPC7448 Hardware Specifications Addendum for the MC7448xxnnnnNx Series, Rev. 6
6 Freescale Semiconductor
General Parameters
Table 7. Power Consumption for MPC7448 at Maximum Rated Frequency
Die
Junction
(T
j
) (•C)C)
Maximum Processor Core Frequency (Speed Grade, MHz)
Unit Notes
600,
667
800,
867
1000 1250 1267
7
1400
Full-Power Mode
Typical, Nominal 65 8.5 9.0 9.5 10.0 8.4 11.0 W 1, 2
Typical, Thermal 105 10.8 11.4 12.0 12.6 10.3 13.7 W 1, 5
Maximum 105 12.5 13.2 13.9 14.6 12.0 15.9 W 1, 3
Nap Mode
Typical 105 6.5 6.5 6.5 8.3 6.5 8.3 W 1, 6
Sleep Mode
Typical 105 6.3 6.3 6.3 8.0 6.3 8.0 W 1, 6
Deep Sleep Mode (PLL Disabled)
Typical 105 6.0 6.0 6.0 7.7 6.0 7.7 W 1, 6
Notes:
1. These values specify the power consumption for the core power supply (V
DD
) at nominal voltage and apply to all valid
processor bus frequencies and configurations. The values do not include I/O supply power (OV
DD
) or PLL supply power
(AV
DD
). OV
DD
power is system dependent but is typically < 5% of V
DD
power. Worst case power consumption for
AV
DD
<13mW.
2. Typical nominal power consumption is an average value measured at the nominal recommended V
DD
(see Ta bl e 4 ) and
65°C while running the Dhrystone 2.1 benchmark and achieving 2.3 Dhrystone MIPs/MHz. This parameter is not 100%
tested but periodically sampled.
3. Maximum power consumption is the average measured at nominal V
DD
and maximum operating junction temperature (see
Table 4 ) while running an entirely cache-resident, contrived sequence of instructions to keep all the execution units
maximally busy.
4. Doze mode is not a user-definable state; it is an intermediate state between full-power and either nap or sleep mode. As a
result, power consumption for this mode is not tested.
5. Typical thermal power consumption is an average value measured at the nominal recommended V
DD
(see Table 4) and
105°C while running the Dhrystone 2.1 benchmark and achieving 2.3 Dhrystone MIPs/MHz. This parameter is not 100%
tested but periodically sampled.
6. Typical power consumption for these modes is measured at the nominal recommended V
DD
(see Tab le 4 ) and 105°C in the
mode described. This parameter is not 100% tested but is periodically sampled.
7. Power consumption for the 1267 MHz device is intentionally constrained via testing and sorting to assure low power
consumption for this device.