XR18W753
18
SINGLE CHIP 868MHZ TO 956MHZ RF TRANSCEIVER REV. 1.0.0
0x27 AGC_ACT_VALUE AGC setting instantaneous value
b[3:0] = 0000 --> IF-AGC set to 0dB
b[3:0] = 0001 --> IF-AGC set to -6dB
b[3:0] = 0010 --> IF-AGC set to -12dB
b[3:0] = 0011 --> IF-AGC set to -18dB
b[3:0] = 0100 --> IF-AGC set to -24dB
b[3:0] = 0101 --> IF-AGC set to -30dB
b[3:0] = 0110 --> IF-AGC set to -36dB
b[3:0] = 0111 --> IF-AGC set to -42dB
b[3:0] = 1000 --> IF-AGC set to -48dB
b[3:0] = 1001 --> not used
b[3:0] = 1010 --> not used
b[3:0] = 1011 --> not used
b[3:0] = 1100 --> not used
b[3:0] = 1101 --> not used
b[3:0] = 1110 --> not used
b[3:0] = 1111 --> not used
b[7:4] not used
R
0x28 Reserved - -
0x29 SLICER_LEVEL Frequency offset in a link can be read out via this register. The
value is interpreted as an 8-bit two’s complement value (-128 to
+127). The conversion from this value to frequency is given below.
For 902 - 928 MHz application, the frequency offset is:
f
offset
= 1MHz x SLICER_LEVEL / 128
For 868 MHz application, the frequency offset is:
f
offset
= 400 kHz x SLICER_LEVEL / 128
R
0x2A-0x2D Reserved - -
0x2E ED_THRES Energy detection threshold
In IEE802.15.4 specification, it has been defined how the result of
the ED measurement given in MODEM_ED (0x15) need to be
reported. The value of ED_THRES is used to align the receiver
with the IEE802.15.4 ED measurement specification.
R/W
0x2F - 0x30 RSSI_ACT_VALUE_0,1 Actual RSSI value_0, 1
The instantaneous level to the digital demodulator can be read via
these two registers. The value is interpreted as a two’s comple-
ment number. Together with the information of AGC_ACT_VALUE
(0x27), the instantaneous RF level can be calculated.
R
0x31-0x4F Reserved - -
0x50 TEST_0 This register is used for factory test modes. For normal operation,
initialize this register to 0xD1.
R/W
3.2 DETAILED REGISTERS DESCRIPTIONS
ADDRESS REGISTER NAME DESCRIPTION TYPE