OM13488 8-bit GPIO User Manual
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2013. All rights reserved.
Rev. 1.0 — 11 October 2013
Table 3. CN2 Fm+ Board Connector
Interrupt to INT LED and JP9 pin 3
Interrupt to INT LED and JP9 pin 3
5.3 CN4 Tester Connector
Generation, inspection and logging of I
2
C-Bus data is easily achieved with third party
development tools from Total Phase (www.totalphase.com) There are two tools called
Aardvark and Beagle that direct connect to this board through CN4.
Note: Since SDA and SCL are both connected to the device under test, the Aardvark and the
Fm+ Development board cannot be used simultaneously. The Beagle, a bus sniffer, does not
have any issues.
Table 4. CN4 Tester Connector
