13
Regulatory Requirements
Passes FCC B and worldwide analogous emission limits
when assembled into a mouse with shielded cable and
following Avago Technologies recommendations.
Passes EN61000-4-4/IEC801-4 EFT tests when
assembled into a mouse with shielded cable and
following Avago Technologies recommendations.
UL ammability level UL94 V-0.
Provides su cient ESD creepage/clearance distance
to withstand discharge up to 15kV when assembled
into a mouse with lens according to usage instructions
above.
Absolute Maximum Ratings
Parameter Symbol Minimum Maximum Units Notes
Storage Temperature T
S
-40 85 °C
Operating Temperature T
A
-15 55 °C
Lead Solder Temp 260 °C For 7 seconds, 1.6mm below seating plane.
Supply Voltage V
DD
-0.5 5.5 V
ESD 2 kV All pins, JESD22-A114
Input Voltage V
IN
-0.5 V
DD
+0.5 V All I/O pins except OSC_IN and OSC_OUT,
D+, D-
Input Voltage V
IN
-1.0 4.6 V D+, D-, AC waveform, see USB speci cation
(7.1.1)
Input Voltage V
IN
-0.5 3.6 V OSC_IN and OSC_OUT
Input Short Circuit Voltage V
SC
0V
DD
V D+, D-, see USB speci cation (7.1.1)
Recommended Operating Conditions
Parameter Symbol Minimum Typical Maximum Units Notes
Operating Temperature T
A
040°C
Power supply voltage V
DD
4.25 5.0 5.25 Volts For accurate navigation and
proper USB operation
Power supply voltage V
ddm
4 5.0 5.25 Volts Maintains communication to
USB host and internal register
contents.
Power supply rise time V
RT
0.003 100 ms
Supply noise V
N
100 mV Peak to peak within 0-80 MHz
bandwidth
Velocity Vel 30 ips
Acceleration Acc 8 g 0.5g from Rest
Clock Frequency f
clk
23.64 24 24.36 MHz Due to USB timing constraints
Resonator Impedance X
RES
55
Distance from lens reference
plane to surface
Z 2.3 2.4 2.5 mm See Figure 9
Frame Rate 4000 fps Internally adjusted by sensor
14
Figure 9. Distance from lens reference plane to object surface
AC Electrical Speci cations
Electrical Characteristics over recommended operating conditions. Typical values at 25°C, V
DD
=5.0 V
Parameter Symbol Min. Typical Max. Units Notes
Wakeup delay from rest
mode due to motion.
T
WUPP
2ms
Power up delay T
PUP
50 ms
Debounce delay on button
inputs
T
DBB
5 10 17 ms “Maximum speci ed at 8ms polling
rate.
Scroll wheel sampling period T
SW
150 200 300 μs ZA PIN for optical scroll wheel
1.9 2.0 2.8 ms ZA PIN for mechanical scroll wheel
Transient Supply Current I
DDT
60 mA Max. supply current during a V
DD
ramp
from 0 to 5.0 V with > 500 s rise time.
Does not include charging currents for
bypass capacitors.
Input Capacitance (OSC Pins) C
OSC_IN
50 pF OCS_IN, OSC_OUT to GND
USB Electrical Speci cations
Electrical Characteristics over recommended operating conditions.
Parameter Symbol Min. Max. Units Notes
Output Signal Crossover Voltage V
CRS
1.5 2.0 V C
L
= 200 to 600 pF (see Figure 10)
Input Signal Crossover Voltage V
ICRS
1.2 2.1 V C
L
= 200 to 600 pF (see Figure 10)
Output High V
OH
2.8 3.6 V
with 15 kohm to Ground and 7.5 k to Vbus
on D- (see Figure 11)
Output Low V
OL
0.0 0.3 V
with 15 kohm to Ground and 7.5 k to Vbus
on D- (see Figure 11)
Single Ended Input V
SEI
0.8 V
Input High (Driven) V
IH
2.0 V
Input High (Floating) V
IHZ
2.7 3.6 V
Input Low V
IL
0.8 V
7.5k to V
DD5
Di erential Input Sensitivity V
DI
0.2 V |(D+)-(D-)| See Figure 12
Di erential Input Common Mode
Range
V
CM
0.8 2.5 V Includes V
DI
, See Figure 12
Single Ended Receiver Threshold V
SE
0.8 2.0 V
Transceiver Input Capacitance C
IN
12 pF D+ to V
BUS
, D- to V
BUS
Z
Sensor
LENS
OBJECT SURFACE
15
USB Timing Speci cations
Timing Speci cations over recommended operating conditions.
Parameter Symbol Min. Max. Units Notes
D+/D- Transition rise time T
LR
75 ns C
L
= 200 pF (10% to 90%), see Figure 10
D+/D- Transition rise time T
LR
300 ns C
L
= 600 pF (10% to 90%), see Figure 10
D+/D- Transition fall time T
LF
75 ns C
L
= 200 pF (90% to 10%), see Figure 10
D+/D- Transition fall time T
LF
300 ns C
L
= 600 pF (90% to 10%), see Figure 10
Rise and Fall time matching T
LRFM
80 125 % T
R
/T
F
; C
L
= 200 pF; Excluding the  rst transi-
tion from the Idle State
Wakeup delay from USB suspend
mode due to buttons push
T
WUPB
17 ms Delay from button push to USB operation
Only required if remote wakeup enabled
Wakeup delay from USB suspend
mode due to buttons push until
accurate navigation
T
WUPN
50 ms Delay from button push to navigation
operation
Only required if remote wakeup enabled
USB reset time T
reset
18.7
s
Data Rate t
LDRATE
1.4775 1.5225 Mb/s Average bit rate, 1.5 Mb/s +/- 1.5%
Receiver Jitter Tolerance t
DJR1
-75 75 ns To next transition, see Figure 13
Receiver Jitter Tolerance t
DJR2
-45 45 ns For paired transitions, see Figure 13
Di erential to EOP Transition Skew t
LDEOP
-40 100 ns See Figure 14
EOP Width at Receiver t
LEOPR
670 ns Accepts EOP, see Figure 14
Source EOP Width t
LEOPT
1.25 1.50
s
Width of SE0 interval during
Di erential Transition
t
LST
210 ns See Figure 11
Di erential Output Jitter t
UDJ1
-95 95 ns To next transition, see Figure 15
Di erential Output Jitter t
UDJ2
-150 150 For paired transitions, see Figure 15
Figure 10. Data Signal Rise and Fall Times
V
CRS
10% 10%
90% 90%
T
LR
Rise Time
T
LF
Fall Time
V
OL
V
OH
D +
D -

ADNS-5700-H3PB

Mfr. #:
Manufacturer:
Broadcom / Avago
Description:
IC USB OPT MOUSE SENSOR 18-DIP
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union