©2010-2014 by Murata Electronics N.A., Inc.
SF2039B (R) 3/27/14 Page 2 of 7
www.murata.com
Matching Circuit and Matching Component Values Used in G3 Sirius Radios
(Refer to Sirius Radio G3 Chipset Application Note, Doc. #RX000104-B, Sec. 4.2.3)
TDM1 Narrowband SAW Matching Values
Reference Designator Value
C5 10 pF
C6 10 pF
L3 330 nH
L4 560 nH
C7 100 pF
C8 100 pF
TDM1 Narrowband SAW Matching Circuit
1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance
matching to 50 Ω and measured with 50 Ω network analyzer.
2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external
impedance matching design. See Application Note No. 42 for details.
4. "LRIP" or "L" after the part number indicates "low rate initial production" and "ENG" or "E" indicates "engineering prototypes."
5. The design, manufacturing process, and specifications of this filter are subject to change.
6. Tape and Reel Standard ANSI / EIA 481.
7. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port
2, so that the filter must always be installed in one direction per the circuit design.
8. US and international patents may apply.
9. Murata, stylized Murata logo, and Murata N.A., Inc. are registered trademarks of Murata Manufacturing Co., Ltd.
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
NOTES:
Copyright © Murata Manufacturing Co., Ltd. All Rights Reserved 2005