ToolStick-F311DC
Rev. 0.2 7
6. Using the C8051F311 Daughter Card as a Development Platform
The prototyping area on the ToolStick C8051F311 daughter card makes it easy to interface to external hardware.
All of the digital I/O pins are available so it possible to create a complete system.
6.1. C8051F311 Pin Connections
It is important to note that if external hardware is being added, some of the existing components on the board can
interfere with the signaling. The following is a list of port pins on the C8051F311 that are connected to other
components:
P0.1, P0.6-These pins are connected directly to the ToolStick Base Adapter's GPIO pins. By default, these
GPIO pins on the Base Adapter are high-impedance pins so they will not affect any signaling. Configuring
these pins on the Base Adapter to output pin or handshaking pins could affect signaling.
P0.4, P0.5-These pins are connected directly to the ToolStick Base Adapter for UART communication.
P0.7-This pin is connected to the "S1" switch. The switch can be removed to disconnect them from the pin.
P1.0-This pin is connected to the cathode of the green LED on the daughter card. The LED or the R2
resistor can be removed to disconnect the LED from the pin.
P1.2-This pin is connected to the output of the potentiometer. R5 (a 0 resistor) can be removed to
disconnect the potentiometer from the pin.
See “7. C8051F311 Daughter Card Schematic” for more information.
6.2. C2 Pin Sharing
On the C8051F311, the debug pins, C2CK, and C2D, are shared with the pins /RST and P0.7 respectively. The
daughter card includes the resistors necessary to enable pin sharing which allow the /RST and P0.7 pins to be
used normally while simultaneously debugging the device. See "AN124: Pin Sharing Techniques for the C2
Interface" at www.silabs.com for more information regarding pin sharing.
