Data Sheet ADG836
Rev. B | Page 13 of 16
TERMINOLOGY
I
DD
Positive supply current.
V
D
(V
S
)
Analog voltage on Terminal D and Terminal S.
R
ON
Ohmic resistance between Terminal D and Terminal S.
R
FLAT (ON)
Flatness is defined as the difference between the maximum and
minimum value of on resistance as measured over the specified
analog signal range.
∆R
ON
On-resistance match between any two channels.
I
S
(OFF)
Source leakage current with the switch off.
I
D
(OFF)
Drain leakage current with the switch off.
I
D
, I
S
(ON)
Channel leakage current with the switch on.
V
INL
Maximum input voltage for Logic 0.
V
INH
Minimum input voltage for Logic 1.
I
INL
(I
INH
)
Input current of the digital input.
C
S
(OFF)
Off switch source capacitance. Measured with reference to
ground.
C
D
(OFF)
Off switch drain capacitance. Measured with reference to
ground.
C
D
, C
S
(ON)
On switch capacitance. Measured with reference to ground.
C
IN
Digital input capacitance.
t
ON
Delay time between the 50% and the 90% points of the digital
input and switch on condition.
t
OFF
Delay time between the 50% and the 90% points of the digital
input and switch off condition.
t
BBM
On or off time measured between the 80% points of both
switches when switching from one to another.
Charge Injection
A measure of the glitch impulse transferred from the digital
input to the analog output during on-off switching.
Off Isolation
A measure of unwanted signal coupling through an off switch.
Crosstalk
A measure of unwanted signal, which is coupled through from
one channel to another as a result of parasitic capacitance.
−3 dB Bandwidth
The frequency at which the output is attenuated by 3 dB.
On Response
The frequency response of the on switch.
Insertion Loss
The loss due to the on resistance of the switch.
Total Harmonic Distortion Plus Noise (THD + N)
The ratio of the harmonics amplitude plus the noise of a signal
to the fundamental.
