ZL38080LDG1

1
© 2014 Microsemi Corporation. All Rights Reserved.
Features
DSP with Voice Hardware Accelerators
Dual ΔΣ DACs with output sampling up to 48 kHz
and internal output drivers
4 single-ended or 2 differential Output Amps
44.1/48 kHz Stereo Music Playback with Voice
A single Digital Microphone input supporting
up to 2 Microphones
Two TDM ports shared between PCM and Inter-
IC Sound (I
2
S)
Each port provides sample rate conversion
and synchronous and asynchronous TDM bus
operation
SPI Slave port for host processor interface
Master SPI port for serial Flash interface
14 General Purpose Input/Output (GPIO) pins
General purpose UART port
Boots from SPI, UART, or Flash allowing easy
firmware updates
Can run unattended (controllerless), self-
booting into a configured operational state
Ultra-low and Standby off power
Full duplex operation supports AEC (up to
256 ms) in both Narrowband and Wideband
operation (8 kHz or 16 kHz respectively)
Psychoacoustic noise reduction
Single microphone
Stationary noise reduction
•AGC/ALC
Dynamic Range Compression
Built-in support for G.712 and G.722
Single and Dual Tone Generation
MiTuner GUI Software
Automated AEC tuning
Applications
Hands-Free Phone and Audio capability for
Automotive applications
Description
The Microsemi AcuEdge Technology ZL38080 Hands-
Free Automotive Audio Processor is designed to
provide leading edge acoustic echo cancellation and
noise reduction for the Hands-Free Automotive market.
The ZL38080 device is a highly adaptable hardware
platform designed to support high performance audio
processing applications. The ZL38080 provides a
powerful DSP with voice specific hardware
accelerators, one digital microphone interface, two
independent 16-bit DACs, and two flexible TDM
interfaces in a single 64-pin QFN package.
The Microsemi AcuEdge Technology ZLS38080
license-free Firmware provides Acoustic Echo
Cancellation (AEC), noise reduction and a variety of
other voice enhancements to improve both the
intelligibility and subjective quality of voice in harsh
acoustic environments.
Performance
AEC Tail Length: 256 ms
AEC sampling rate: 8 and 16 kHz
Single Talk TCLw: > 60 dB
Double Talk TCLw: > 40 dB
Double Talk Attenuation: < 3 dB
Noise reduction up to 30 dB
Document ID# 149152 Version 2 May 2014
Ordering Information
Device OPN
(1)
Package Packing
ZL38080LDF1 64-pin QFN (9x9) Tape & Reel
ZL38080LDG1 64-pin QFN (9x9) Tray
1. The Green package meets RoHS 2 Directive 2011/65/EU of the
European Council to minimize the environmental impact of
electrical equipment.
Microsemi
®
AcuEdge™ Technology
ZL38080
Hands-Free Automotive Audio Processor
Product Brief
ZL38080
Product Brief
2
© 2014 Microsemi Corporation. All Rights Reserved.
Voice Processing Series Solution Overview
Designed for world-class high definition voice applications, Microsemi’s new ZL380 series of audio processors
features the company’s Microsemi AcuEdge™ Technology. This innovative technology is a set of highly-complex
and integrated algorithms that allows the user to extract more information from the audio environment. The new
Microsemi AcuEdge Technology consists of license-free, royalty-free intelligent audio IP algorithms. When
combined with Microsemi’s highly-integrated ZL380 series of audio processors, the solution accelerates customers
time-to-market via validated reference design and easy-to-use development tools including the Microsemi Audio
Interface Box (AIB) Kit which utilizes the MiTuner™ GUI software.
ZL38080 Block Diagram
The ZL38080 Hands-Free Automotive Audio Processor provides the following enhanced voice processing feature
set.
Microsemi ZL38080 Hardware
Host Interface: SPI, UART, I
2
C
Standalone (controllerless) auto-boot from Flash
Two clock independent TDM ports (PCM or I
2
S)
14 GPIOs, configurable with built-in control features
Crystal-less operation (with a valid TDM clock)
Digital microphone interface supporting one or two digital microphones
PCMA/I
2
SA
Host Bus Interface
TDM
PCM/I
2
S
Master SPI
PLL
UART
GPIO
PCMB/I
2
SB
SPI Slave/I
2
C Slave
Flash
UART
GPIO
Crystal
DSP
Integrated
Memory
Hardware
Accelerators
DAC1
DAC2
Decimation
Filter
Speaker 1
Speaker 2
Digital
Mics
ZL38080
Product Brief
3
© 2014 Microsemi Corporation. All Rights Reserved.
Dual 16-bit digital-to-analog converters (DACs)
Headphone amps capable of four single-ended or two differential outputs
Two independent headphone drivers
32 mW output drive power into 16 ohms
Impulse pop/click protection
Microsemi AcuEdge™ Technology
ZLS38080 Firmware
Wideband and Narrowband Acoustic Echo Cancellation
Initial convergence conditioning
Psychoacoustic noise reduction
Single microphone
Stationary noise reduction
Low active power consumption
Multi-tone generation
Signal mixing
44.1 kHz/48 kHz music mixed with 8 kHz/16 kHz voice
Howling detection/cancellation
Various encoding/decoding options:
16-bit 2’s complement (linear)
G.711 A/μ law
•G.722
Send and receive path equalizers
16-band for Narrowband mode
22-band for Wideband mode
Comfort noise generation
44.1 kHz/48 kHz bypass mode
Configurable Cross-Point Switch
AEC Auto-Tuning
To optimize the acoustic properties of a given system design, the Audio Processor firmware requires gain and level
tuning. The mechanical design, including the speaker and microphone quality and placement, will all affect the
system’s acoustic performance. Microsemi has developed MiTuner GUI Software (ZLS38508) and the Microsemi
Audio Interface Box (AIB) hardware (ZLE38470) to automatically optimize the firmware’s tunable parameters for a
given hardware design, facilitating the system design process and eliminating the need for tedious manual tuning.
The MiTuner GUI Software provides step-by-step instructions that allow the software’s algorithms to achieve a high
level of acoustic performance for a given enclosure.

ZL38080LDG1

Mfr. #:
Manufacturer:
Microchip / Microsemi
Description:
Audio DSPs Audio processor with Single Microphone support for automotive apps.
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union

Products related to this Datasheet