DATA SHEET • SKY65135 WLAN PA
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • sales@skyworksinc.com • www.skyworksinc.com
4 March 28, 2007 • Skyworks Proprietary and Confidential information • Products and Product Information are Subject to Change Without Notice • 200436D
Table 4. SKY65135 Electrical Specifications
(VCC1 = VCC2 = 3.3 V, VCC3 = 5 V, T
C = +25 °C, Test Frequency = 2.442 GHz unless otherwise noted)
Parameter Symbol Test Condition Min Typical Max Units
Using IEEE802.11b Complimentary Code Keying Input Signal, Data Rate = 11 Mbps
Total supply current ICC_TOTAL 1150 mA
Output power (Note 1) POUT 31 dBm
Power added efficiency (Note 2) PAE 25 %
Ramp-up/ramp-down (Note 3) TS <0.5 µs
Using IEEE802.11g Orthogonal Frequency Division Multiplexing Input Signal, Data Rate = 54 Mbps
Total supply current ICC_TOTAL 1050 mA
Output power (Note 4) POUT 30 dBm
Output power @ EVM = 3% POUT_EVM 27 dBm
Power added efficiency (Note 2) PAE 22 %
Using Continuous Wave Input Signals
Small signal gain G PIN = –25 dBm 31.5 33 34.5 dB
Gain flatness over band From 2.4 GHz to 2.5 GHz ±0.5 dB
Gain flatness over channel (16.25 MHz) Over any 16.25 MHz
within band
±0.1 dB
Output power @ 1 dB compression P1dB PIN = 0 dBm 32 33 dBm
Output IP3 OIP3 PTONE = +27 dBm,
Delta_freq = 5 MHz
42 dBm
Quiescent Current IQ No RF input 400 450 mA
Noise Figure NF 5 6 dB
Power added efficiency @ P1dB PAE 25 34 %
Note 1: Defined as the maximum power level for which the IEEE802.11b transmit mask requirements are met.
Note 2: Measured at the specified average output RF power and modulation type.
Note 3: Ramp-up and ramp-down times are defined from the 10% to 90% power points.
Note 4: Defined as the maximum power level for which the IEEE802.11g transmit mask requirements are met.
