FTLX6611MCC and FTLX6614MCC T-XFP Product Specification
Finisar Corporation August 2015 Rev. B1 Page 16
XI. Notes & Exceptions
• XFI loopback operation:
o When XFI Loopback is enabled, the Transmitter output is disabled.
o When Line Loopback is enabled, the CDR output is disabled.
• 8.5Gb/s operation requires configuration change via I2C vendor reserved
command.
XII. References
1. 10 Gigabit Small Form Factor Pluggable Module (XFP) Multi-Source Agreement
(MSA), Rev 4.5 – August 2005. Documentation is currently available
at http://www.xfpmsa.org/
2. Application Note AN-2035: “Digital Diagnostic Monitoring Interface for XFP
Optical Transceivers” – Finisar Corporation, December 2003
3. Directive 2011/65/EU of the European Council Parliament and of the Council,
“on the restriction of the use of certain hazardous substances in electrical and
electronic equipment”. Certain products may use one or more exemptions as
allowed by the Directive.
4. “Application Note AN-2038: Finisar Implementation of RoHS Compliant
Transceivers”.
5. SFF-8477 Revision 1.3: “Specification for Tunable XFP for ITU Frequency Grid
Applications”. October 20
th
, 2008. Documentation is currently available at
ftp://ftp.seagate.com/sff
XIII. Product Selection Details
FTLX6611MCC-xx/ FTLX6614MCC-xx
FT: FT Series
L: RoHS-6
X: 10G Bit Rate Class
66: 40km (symmetric chirp) widely tunable with PIN Receiver
1: XFP form factor
1: Gen 1 (Standard Performance), 4: Gen 1 (High-Performance)
M: Multiprotocol, 8.5Gb/s supported with I2C command
C: Commercial temperature range
C: ITU-T C-Band 50GHz spacing
xx: customer specific (not required for standard configuration)
