NTB0104_Q100 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2013. All rights reserved.
Product data sheet Rev. 2 — 18 April 2013 4 of 23
NXP Semiconductors
NTB0104-Q100
Dual supply translating transceiver; auto direction sensing; 3-state
7. Functional description
[1] H = HIGH voltage level; L = LOW voltage level; X = don’t care; Z = high-impedance OFF-state.
[2] When either V
CC(A)
or V
CC(B)
is at GND level, the device goes into power-down mode.
8. Limiting values
[1] The minimum input and minimum output voltage ratings may be exceeded if the input and output current ratings are observed.
[2] V
CCO
is the supply voltage associated with the output.
[3] V
CCO
+ 0.5 V should not exceed 6.5 V.
[4] For DHVQFN14 packages: above 60 C the value of P
tot
derates linearly with 4.5 mW/K.
GND 7 D2 ground (0 V)
OE 8 C2 output enable input (active HIGH; referenced to V
CC(A)
)
B4, B3, B2, B1 10, 11, 12, 13 D1, C1, B1, A1 data input or output (referenced to V
CC(B)
)
V
CC(B)
14 A2 supply voltage B
Table 3. Pin description …continued
Symbol Pin Ball Description
SOT762-1 WLCSP12
Table 4. Function table
[1]
Supply voltage Input Input/output
V
CC(A)
V
CC(B)
OE An Bn
1.2 V to V
CC(B)
1.65 V to 5.5 V L Z Z
1.2 V to V
CC(B)
1.65 V to 5.5 V H input or output output or input
GND
[2]
GND
[2]
XZZ
Table 5. Limiting values
In accordance with the Absolute Maximum Rating System (IEC 60134). Voltages are referenced to GND (ground = 0 V).
Symbol Parameter Conditions Min Max Unit
V
CC(A)
supply voltage A 0.5 +6.5 V
V
CC(B)
supply voltage B 0.5 +6.5 V
V
I
input voltage
[1]
0.5 +6.5 V
V
O
output voltage Active mode
[1][2][3]
0.5 V
CCO
+0.5 V
Power-down or 3-state mode
[1]
0.5 +6.5 V
I
IK
input clamping current V
I
<0V 50 - mA
I
OK
output clamping current V
O
<0V 50 - mA
I
O
output current V
O
=0VtoV
CCO
[2]
- 50 mA
I
CC
supply current I
CC(A)
or I
CC(B)
-100mA
I
GND
ground current 100 - mA
T
stg
storage temperature 65 +150 C
P
tot
total power dissipation T
amb
= 40 C to +125 C
[4]
-250mW