GP1A173LCSVF
1
Notice The content of data sheet is subject to change without prior notice.
In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that may occur in equipment using any SHARP
devices shown in catalogs, data books, etc. Contact SHARP in order to obtain the latest device specification sheets before using any SHARP device.
GP1A173LCSVF is a standard, OPIC output,
transmissive photointerrupter with opposing emitter
and detector in a case, providing non-contact sensing.
For this family of devices, the emitter and detector are
inserted in a case, and a 3-pin connector is included to
allow remote-mount or off-board designs.
1. Transmissive with OPIC output
2. Highlights :
・Special position hooks compatible with 3 different
Plate thicknesses (1.0, 1.2, 1.6mm)
・Snap insertion
3. Key Parameters :
・Gap Width : 5mm
・Slit Width (detector side) : 0.5mm
・Package : 17 × 12.8 × 8mm (without connector
and hooks)
・Connector : Tyco Electronics JAPAN G.K.
(173977-3 and 179228-3)
4. RoHS directive compliant
1. Compliant with RoHS directive (2002/95/EC)
1. General purpose detection of object presence or
motion.
Example : PPC, FAX, Printer
■Agency approvals/Compliance
Gap : 5.0mm Slit : 0.5mm
*OPIC Output, Snap-in type
Compact Transmissive
Photointerrupter with connector
*”OPIC”(Optical IC) is a trademark of the SHARP Corporation. An OPIC consists of a light-detecting element and
a signal-processing