MP26075 – HIGH EFFICIENCY CRADLE CHARGER
MP26075 Rev. 1.01 www.MonolithicPower.com 10
5/23/2011 MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.
© 2011 MPS. All Rights Reserved.
Table 2— Charge Status Indication
LED-R LED-G Status
High High Fault/toggle
Low High Normal charge
High Low End of charge
Compensation
COM pin is used to compensation Vin control
loop. Connect a Resistor and a capacitor
between COM pin and CTL pin to keep system’s
stability. 100nF capacitor and several kilo-ohms
resistor are recommended. And for specific
design, please refer to application information of
the primacy flyback controller.
VCC
0V
5V
BATT+0.5V
VBATT
Recharge
Trickle
charge
detection
CC charge
detection
2.0V
3.0V
Battery regulation
voltage
CV charge
detection
0A
ON OFF
ON
OFF
LED-R
LED-G
ON
OFF
Fast Charge
Trickle
Charge
Pre-
Charge
IBATT
1mA
10%Ichg
Ichg
10%Ichg
Figure 3— Typical Charge Profile