MP26075 – HIGH EFFICIENCY CRADLE CHARGER
MP26075 Rev. 1.01 www.MonolithicPower.com 4
5/23/2011 MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.
© 2011 MPS. All Rights Reserved.
PIN FUNCTIONS
Pin # Name Description
1 VIN Input Supply Pin. Decoupling Capacitor is needed to prevent large voltage spikes.
2 LED-G
Open-Drain Charge status Indicator. This pin is high during charge and fault condition, is low
after battery full or termination.
3 LED-R
Open-Drain Charge status Indicator. This pin is low during charge, is high after battery full or
termination and fault condition.
4 TMR
Pin of the oscillator. Connect a capacitor from this pin to GND to set the oscillator cycle. Timer
setting time changes according to oscillation cycle.
5 GND GND pin.
6 COM Compensation for VIN limits circuit.
7 CTL
CTL is used for VIN control. Connect to the cathode of photo diode of photo coupler by a
resistor.
8 ISET Connect a resistor R between ISET and GND of Battery Pack to set the charge current.
9 NTC
Battery temperature monitoring pin. Connect a resistor from this pin to VIN and connect this pin
to the thermistor pin of the battery pack.
10 BATT Charger Output terminal.