MINI MCR-SL-PTB-FM
105449_en_00 PHOENIX CONTACT 7
6.6 Assembly
Figure 3 Mounting and removing
– Mount the module on a 35 mm DIN rail according to EN
60715.
– When using the DIN rail connector, first place it into the
DIN rail (see A – C). It is used to bridge the power supply.
It is also absolutely vital that you snap the module and the
DIN rail connector into position in the correct direction:
the snap-on foot should be at the bottom and the connec-
tor on the left.
6.7 Connecting the wires
The module is available in two connection versions:
– Screw terminal blocks (for MINI MCR-SL-PTB-FM)
– Spring-cage terminal blocks (for MINI MCR-SL-PTB-FM-
SP)
Screw connection:
Figure 4 Screw connection
• Insert the wire into the corresponding connection terminal
block.
• Use a screwdriver to tighten the screw in the opening
above the connection terminal block.
Spring-cage connection:
Figure 5 Spring-cage connection
• Insert a screwdriver into the opening above the connec-
tion terminal block.
• Insert the wire into the corresponding connection terminal
block.
For additional mechanical redundancy, two
power terminals and two fault monitoring mod-
ules can be used. Only one supply may be con-
nected to each power terminal. In the second
fault monitoring module, fault monitoring of ex-
ternal measuring transducers must be deacti-
vated because evaluation can only take place
via a module in a group.
www.interface.phoenixcontact.com
Serial No. XXXXXXXX
A
B
www.interface.phoenixcontact.com
Serial No. XXXXXXXX
A
B
