|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||| |||||||||||||||||
All trademarks are property of their respective owners 2014-08-0001 www.pericom.com PT0516 8/27/14
3
PI5USB2549
USB Charging Port Controller and Load Detection Power Switch
Maximum Ratings
All Input (except IN to OUT, and DP_IN, DM_IN)....................................................... -0.3V to +6.0V
IN to OUT ................................................................................................................................. -6.0V to +6.0V
DP_IN, DM_IN .................................................................................................. -0.3V to IN+0.3 or +5.7V
Input clamp current (DP_IN, DM_IN) ............................................................................................ ±20mA
Continuous current in BC1.2 DCP mode (DP_IN to DM_IN) ................................................ ±50mA
Continuous output current (OUT) ..................................................................................... Internally limited
Continuous output sink current (/STATUS)...................................................................................... 25mA
Continuous output source current (ILIM)........................................................................ internally limited
ESD: HBM Mode (All pins) ................................................................................................................... 2kV
CDM Mode (All pins) ........................................................................................................................... 500V
HBM (USB connector pins: DP_IN, DM_IN, OUT to GND)....................................................... 6kV
Recommended Operating Conditions
Input Voltage, logic-level MODE_SEL input
High-level input voltage, MODE_SEL
Low-level input voltage, MODE_SEL
Continuous output current, OUT
Continuous output sink current, /STATUS
Current-limit set resistor
Ambient Temperature Range
Operating Virtual Junction Temperature Range
Note:
Stresses greater than those listed under MAXIMUM
RATINGS may cause permanent damage to the device.
This is a stress rating only and functional operation of the
device at these or any other conditions above those
indicated in the operational sections of this specification
is not implied. Exposure to absolute maximum rating
conditions for extended periods may affect reliability.