|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||| |||||||||||||||||
All trademarks are property of their respective owners 2014-08-0001 www.pericom.com PT0516 8/27/14
6
PI5USB2549
USB Charging Port Controller and Load Detection Power Switch
Electrical Characteristics, Charging Controller
4.5V≤V
IN
≤5.5V; T
J
=-40°C to +125°C; R
/STATUS
=10kΩ R
ILIM
=20kΩ
Positive currents are into pins. Typical values are at 25°C. All voltages are with respect to GND. unless otherwise specified.
DP_IN/DM_IN shorting resistance
DP_IN/DM_IN output voltage
Apply 3V on DP_IN for 0.5s and
measure the D+/D- voltage within the 2s
DP_IN/DM_IN output impedance
DP_IN Divider-1A output voltage
DM_IN Divider-1A output voltage
DP_IN/DM_IN output impedance
DP_IN Divider-2A output voltage
DM_IN Divider-2A output voltage
DP_IN/DM_IN output impedance
DIVIDER-2.4A MODE (with MODE_SEL=’HIGH’)
DP_IN/DM_IN output voltage
DP_IN/DM_IN output impedance
I
PLUG_IN
rising set current threshold
I
PLUG_IN
falling reset current
threshold
Plug-in detect reset time
Note:
(1) These parameters are provided for reference only and do not constitute part of Pericom's published device specifications for purposes of
Pericom's product warranty.