XRA1404
7
REV. 1.0.0 8-BIT SPI GPIO EXPANDER WITH INTEGRATED LEVEL SHIFTERS
2.9 Input Rising Edge Interrupt Enable Register (REIR) - Read/Write
Writing a ’1’ to these bits will enable the corresponding input to generate an interrupt on the rising edge. See
Table 3 for complete details of the interrupt behavior for various register settings. The MSB of this register
corresponds with P7 and the LSB of this register corresponds with P0.
2.10 Input Falling Edge Interrupt Enable Register (FEIR) - Read/Write
Writing a ’1’ to these bits will enable the corresponding input to generate an interrupt on the falling edge.
Writing a ’1’ to these bits will make that input generate an interrupt on the rising edge only. See
Table 3 for
complete details of the interrupt behavior for various register settings. The MSB of this register corresponds
with P7 and the LSB of this register corresponds with P0.
2.11 Input Filter Enable Register (IFR) - Read/Write
By default, the input filters are enabled (IFR = 0xFF). When the input filters are enabled, any pulse that is
greater than 1075ns will generate an interrupt (if enabled). Pulses that are less than 225ns will be filtered and
will not generate an interrupt. Pulses in between this range may or may not generate an interrupt. Writing a ’0’
to these bits will disable the input filter for the corresponding inputs. With the input filters disabled, any change
on the inputs will generate an interrupt (if enabled). See
Table 3 for complete details of the interrupt behavior
for various register settings. The MSB of this register corresponds with P7 and the LSB of this register
corresponds with P0.
ABSOLUTE MAXIMUM RATINGS
Power supply voltage 3.6 Volts
Supply current 160 mA
Ground current 200 mA
External current limit of each GPIO 25 mA
Total current limit for GPIO[7:0] 100 mA
Total supply current sourced by all GPIOs 160 mA
Operating Temperature
-40
o
to +85
o
C
Storage Temperature
-65
o
to +150
o
C
Power Dissipation 200 mW
TYPICAL PACKAGE THERMAL RESISTANCE DATA (MARGIN OF ERROR: ± 15%)
Thermal Resistance (16-QFN)
theta-ja = 40
o
C/W, theta-jc = 26
o
C/W
Thermal Resistance (16-TSSOP)
theta-ja = 105
o
C/W, theta-jc = 20
o
C/W
XRA1404
8
8-BIT SPI GPIO EXPANDER WITH INTEGRATED LEVEL SHIFTERS REV. 1.0.0
ELECTRICAL CHARACTERISTICS
DC ELECTRICAL CHARACTERISTICS
UNLESS OTHERWISE NOTED: TA = -40
O
TO +85
O
C, VCC IS 1.65V TO 3.6V
SYMBOL PARAMETER
LIMITS
±
MIN MAX
LIMITS
±
MIN MAX
LIMITS
±
MIN MAX
UNITS CONDITIONS
V
IL
Input Low Voltage -0.3 0.2 -0.3 0.5 -0.3 0.8 V Note 1
V
IH
Input High Voltage 1.4 5.5 1.8 5.5 2.0 5.5 V Note 1
V
OL
Output Low Voltage
0.4
0.4
0.4 V
V
V
I
OL
= 6 mA
I
OL
= 4 mA
I
OL
= 1.5 mA
Note 2 &
Note 4
V
OL
Output Low Voltage 0.5 0.5 0.5 V I
OL
= 8 mA
Note 3
V
OH
Output High Voltage
1.4
1.8
2.0 V
V
V
I
OL
= -4 mA
I
OL
= -2 mA
I
OL
= -0.2 mA
Note 2
V
OH
Output High Voltage
1.2
1.8
2.6 V
V
V
I
OH
= -8 mA
I
OH
= -8 mA
I
OH
= -8 mA
Note 3
I
IL
Input Low Leakage Current ±10 ±10 ±10 uA
I
IH
Input High Leakage Current ±10 ±10 ±10 uA
C
IN
Input Pin Capacitance 5 5 5 pF
I
CC
Power Supply Current 0.5 1.0 2.0 mA Test 1
I
CC
Power Supply Current 0.6 1.2 2.4 mA Test 2
I
CCS
Standby Current 1 2 5 uA Test 3
R
GPIO
GPIO pull-up resistance 60 140 60 140 60 140
k
100k± 40%
XRA1404
9
REV. 1.0.0 8-BIT SPI GPIO EXPANDER WITH INTEGRATED LEVEL SHIFTERS
NOTE: The Vcc comes from VCCP pin for the GPIOs and the VCC pin for the other signals;
NOTES:
1. For SPI input signals (SI, SCL) & GPIOs, A0, A1 and A2 signals;
2. For SPI output signal SO;
3. For GPIOs;
4. For IRQ# signal;
Test 1: SCL frequency is 10 MHz with internal pull-ups disabled. All GPIOs are configured as inputs. All inputs are steady at
VCC or GND. Outputs are floating or in the tri-state mode.
Test 2: SCL frequency is 10 MHz with internal pull-ups enabled. All GPIOs are configured as inputs. All inputs are steady at
VCC or GND. Outputs are floating or in the tri-state mode.
1.8V 10% 2.5V 10% 3.3V 10%

XRA1404IG16-F

Mfr. #:
Manufacturer:
MaxLinear
Description:
Interface - I/O Expanders 8 Bit SPI GPIO Expande
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union