7
LTC3736
3736fa
FU CTIO AL DIAGRA
U
U
W
–
+
–
+
–
+
–
+
SHDN
0.6V
V
REF
EXTSS
0.7µA
BURSTDIS
CLK1
CLK2
FCB
0.54V
V
FB1
V
FB2
FCB
0.6V
SLOPE1
SLOPE2
RUN/SS
V
IN
C
VIN
V
IN
(TO CONTROLLER 1, 2)
R
VIN
SYNC/FCB
PLLLPF
UNDERVOLTAGE
LOCKOUT
BURST DEFEAT/
SYNC DETECT
VOLTAGE
CONTROLLED
OSCILLATOR
SLOPE
COMP
VOLTAGE
REFERENCE
t
SEC
= 1ms
INTSS
PHASE
DETECTOR
IPROG1
IPROG2
IPRG1
IPRG2
VOLTAGE
CONTROLLED
OSCILLATOR
MAXIMUM
SENSE VOLTAGE
SELECT
PGOOD
SHDN
OV1
UV1
UV2
OV2
3736 FD
(Common Circuitry)
For auxiliary winding applications, connect to a resistor
divider from the auxiliary output. To synchronize with an
external clock using the PLL, apply a CMOS compatible
clock with a frequency between 250kHz and 850kHz. To
select Burst Mode operation at light loads, tie this pin to V
IN
.
Grounding this pin selects forced continuous operation,
which allows the inductor current to reverse. When
synchronized to an external clock, pulse-skipping operation
is enabled at light loads.
BG1/BG2 (Pins 19, 13/Pins 22, 16): Bottom (NMOS) Gate
Drive Output. These pins drive the gates of the external N-
channel MOSFETs. These pins have an output swing from
PGND to SENSE
+
.
SENSE1
+
/SENSE2
+
(Pins 21, 11/Pins 24, 14): Positive
Input to Differential Current Comparator. Also powers the
gate drivers. Normally connected to the source of the ex-
ternal P-channel MOSFET.
SW1/SW2 (Pins 22, 10/Pins 1, 13): Switch Node Connec-
tion to Inductor. Also the negative input to differential peak
current comparator and an input to the reverse current
comparator. Normally connected to the drain of the exter-
nal P-channel MOSFETs, the drain of the external N-channel
MOSFET and the inductor.
IPRG1/IPRG2 (Pins 23, 2/Pins 2, 5): Three-State Pins to
Select Maximum Peak Sense Voltage Threshold. These pins
select the maximum allowed voltage drop between the
SENSE
+
and SW pins (i.e., the maximum allowed drop
across the external P-channel MOSFET) for each channel.
Tie to V
IN
, GND or float to select 204mV, 85mV or 125mV
respectively.
V
FB1
/V
FB2
(Pins 24, 7/Pins 3, 10): Feedback Pins. Receives
the remotely sensed feedback voltage for its controller from
an external resistor divider across the output.
UU
U
PI FU CTIO S
(UF/GN Package)
