DocID025558 Rev 2 7/13
ESDAVLC8-1BT2Y Package information
13
Note: Product marking may be rotated by multiples of 90° for assembly plant differentiation. In no
case should this product marking be used to orient the component for its placement on a
PCB. Only pin 1 mark is to be used for this purpose.
Table 3. SOD882T dimension values
Ref.
Dimensions
Millimeters Inches
Min. Typ. Max. Min. Typ. Max.
A 0.30 0.40 0.012 0.016
A1 0.00 0.05 0.000 0.002
b1 0.45 0.50 0.55 0.018 0.020 0.022
b2 0.45 0.50 0.55 0.018 0.020 0.022
D 0.55 0.60 0.65 0.022 0.024 0.026
E 0.95 1.00 1.05 0.037 0.039 0.041
e 0.60 0.65 0.70 0.024 0.026 0.028
L1 0.20 0.25 0.30 0.008 0.010 0.012
L2 0.20 0.25 0.30 0.008 0.010 0.012
Figure 18. SOD882T footprint in mm
(inches)
Figure 19. SOD882T marking
0.55
(0.022)
0.40
(0.016)
0.50
()0.020
0.55
(0.022)
