Spec No. JETE243A-0036C-01 P 7/7
MURATA MFG.CO., LTD
Reference Only
11.9 Magnetic Saturation
When the excessive current over rated current is applied, the inductance value may change due to magnetism.
11.10 Handling of a substrate
After mounting products on a substrate, do not apply any stress to the product caused by bending or twisting
to the substrate when cropping the substrate, inserting and removing a connector from the substrate or
tightening screw to the substrate.
Excessive mechanical stress may cause cracking in the product.
Bending Twisting
11.11 Storage and Handing Requirements
(1) Storage period
Use the products within 6 months after delivered.
Solderability should be checked if this period is exceeded.
(2) Storage conditions
・Products should be stored in the warehouse on the following conditions.
Temperature ： -10°C to 40°C
Humidity
： 15% to 85% relative humidity No rapid change on temperature and humidity
Don't keep products in corrosive gases such as sulfur, chlorine gas or acid, or it may cause oxidization of
electrode, resulting in poor solderability.
・Products should be stored on the palette for the prevention of the influence from humidity, dust and so on.
・Products should be stored in the warehouse without heat shock, vibration, direct sunlight and so on.
・Products should be stored under the airtight packaged condition.
(3) Handling Condition
Care should be taken when transporting or handling product to avoid excessive vibration or mechanical
shock.
12． Note
(1)Please make sure that your product has been evaluated in view of your specifications with our product being
mounted to your product.
(2)You are requested not to use our product deviating from the reference specifications.
(3)The contents of this reference specification are subject to change without advance notice.
Please approve our product specifications or transact the approval sheet for product specifications
before ordering.
