F339X2 305VAC
www.vishay.com
Vishay BCcomponents
Revision: 27-Feb-18
12
Document Number: 26072
For technical questions, contact: rfi@vishay.com
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000
SUB-GROUP C5
4.16 Radio frequency characteristic Resonance frequency 0.9 times the value as specified in section
“Resonant Frequency” of this specification
SUB-GROUP C6
4.17 Passive flammability
Class B
Bore of gas jet: Ø 0.5 mm
Fuel: butane / propane
Test duration for actual volume V in mm
3
:
After removing test flame from capacitor,
the capacitor must not continue to burn for
more than 10 s for V > 1750 mm
3
. No burning
particle must drop from the sample.
Class B
V > 1750 60 s
One flame application:
SUB-GROUP C7
4.18 Active flammability 20 cycles of 2.5 kV discharges on the test
capacitor connected to U
RAC
The cheese cloth around the capacitors shall
not burn with a flame.
No electrical measurements are required.
AUTOMOTIVE AEC-Q200, REVISION D QUALIFICIATION
STRESS REVISION CONDITION
SAMPLE
SIZE
PERFORMANCE REQUIREMENTS
1. High
temperature
exposure
(storage)
D Temp.: 105 ºC; unpowered
250 h / 500 h / 1000 h
77 |C/C| 5 %
Increase of tan :
0.008 for C 1 µF at 10 kHz
Increase of tan :
0.005 for C > 1 F at 1 kHz
IR > 50 % of initial specified value
2. Temperature
cycling
D Total no. of cycles: 1000 cycles
Lower temp.: -40 °C
Upper temp: +105 °C
30 min dwell time at each temperature
Transition time < 1 min
77 |C/C| 5 %
Increase of tan : 0.008 for C 1 µF at 10 kHz
IR > 50 % of initial specified value
3. Moisture
resistance
No. of cycle: 10 cycles
t = 24 h/cycle
77 |C/C| 5 %
Increase of tan : 0.008 for C 1 µF at 10 kHz
IR > 50% of initial specified value
4. Biased
humidity AC
D Temp.: 40 °C; RH: 93 %; U
RAC
250 h / 500 h / 1000 h
77 |C/C| 10 %
Increase of tan : 0.008 for C 1 µF at 10 kHz
IR > 50 % of initial specified value
5. Operational
life AC
D Temp. = 105 °C; U
RAC
1000 h 77 |C/C| 10 %
Increase of tan : 0.008 for C 1 µF at 10 kHz
IR > 50 % of initial specified value
6. Terminal
strength
(leaded)
D Test leaded device lead integrity only.
- A (pull-test): 2.27 kg (10 s)
- C (wire-lead bend test): 227 g (3 x 3 s)
30 No visual damage
INSPECTION REQUIREMENTS
SUB-CLAUSE NUMBER AND TEST CONDITIONS PERFORMANCE REQUIREMENTS