DS3501
High-Voltage, NV, I
2
C POT with Temp Sensor
and Lookup Table
____________________________________________________________________ 13
Reading multiple bytes from a slave: The read opera-
tion can be used to read multiple bytes with a single
transfer. When reading bytes from the slave, the master
simply ACKs the data byte if it desires to read another
byte before terminating the transaction. After the master
reads the last byte it must NACK to indicate the end of
the transfer and generates a STOP condition.
Applications Information
Power-Supply Decoupling
To achieve the best results when using the DS3501,
decouple both the power-supply pin and the wiper-bias
voltage pin with a 0.01µF or 0.1µF capacitor. Use a
high-quality ceramic surface-mount capacitor if possi-
ble. Surface-mount components minimize lead induc-
tance, which improves performance, and ceramic
capacitors tend to have adequate high-frequency
response for decoupling applications.
SDA and SCL Pullup Resistors
SDA is an I/O with an open-collector output that
requires a pullup resistor to realize high-logic levels. A
master using either an open-collector output with a
pullup resistor or a push-pull output driver can be used
for SCL. Pullup resistor values should be chosen to
ensure that the rise and fall times listed in the
I
2
C AC
Electrical Characteristics
are within specification. A typ-
ical value for the pullup resistors is 4.7kΩ.
Chip Information
TRANSISTOR COUNT: 22,400
SUBSTRATE CONNECTED TO GROUND
C TRANSACTIONS (WHEN A0 AND A1 ARE CONNECTED TO GND).
*THE SLAVE ADDRESS IS DETERMINED BY ADDRESS PINS A0 AND A1.
