TP 04M, TP 06M, TP 06S, TP 07T
7313_en_03 PHOENIX CONTACT 4
4Mounting
The device enables quick and easy mounting from the rear.
Ideally, mounting should be in control panels with a plate
thickness of approximately 1 mm to 6 mm.
1. Push the device through the mounting cutout from the
front.
Figure 1 Mounting with mounting bracket
2. Place the mounting brackets in the appropriate slots (1)
and pull the brackets downwards until they snap into
place (2).
3. Secure the device using the threaded pins (3).
When mounting the touch panel, leave a
circumferential gap of at least 30 mm in order
to provide sufficient air circulation.
If the touch panel is mounted horizontally,
please note that additional heat sources may
cause a build-up of heat below the touch
panel.
Provide sufficient heat dissipation!
Please observe the permissible temperature
range specified in the technical data when
operating the device.
In order to ensure the specified degree of
protection, make sure that the grommet lies
flat against the mounting surface and the
threaded pins of the mounting brackets are
tightened uniformly.